This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Camera Installation in a Pressurized Part 23 Aircraft
Technical Paper
2004-01-1808
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper describes some of the steps necessary to certificate a camera installation in a Part 23 aircraft. The camera is large and necessitates the severing of a major structural member (keel beam). Damage tolerance analysis is required because of the penetration of the pressure vessel. Cable rerouting is necessary because of the location of the hole. The design, the basis for the structural substantiation and the structural substantiation of this design are discussed in this paper.
Recommended Content
Technical Paper | High Pressure Aircraft Hydraulic Test Stand |
Technical Paper | Non-Electrically Invasive Liquid Level Measurement |
Technical Paper | Determination of Cooling Air Mass Flow for a Horizontally - Opposed Aircraft Engine Installation# |