This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of an Engine Management Strategy and a Cost Effective Catalyst System to Meet SULEV Emission Requirements Demonstrated on a V-6 Engine
Technical Paper
2004-01-1490
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The study presented in this paper focuses on measures to minimize exhaust gas emissions to meet SULEV targets on a V6 engine by using a cost efficient system configuration.
The study consists of three parts.
- A)In the first stage, the influence of engine management both on raw emissions and catalyst light off performance was optimized.
- B)Afterwards, the predefined high cell density catalyst system was tested on an engine test bench. In this stage, thermal data and engine out emissions were used for modeling and prediction of light-off performance for further optimized catalyst concepts.
- C)In the final stage of the program, the emission performance of the test matrix, including high cell density as well as multifunctional single substrate systems, are studied during the FTP cycle.
The presented results show the approach to achieve SULEV emission compliance with innovative engine control strategies in combination with a cost effective metallic catalyst design.
Recommended Content
Authors
Citation
Oertel, H., Wildner, O., Mueller-Haas, K., and Presti, M., "Development of an Engine Management Strategy and a Cost Effective Catalyst System to Meet SULEV Emission Requirements Demonstrated on a V-6 Engine," SAE Technical Paper 2004-01-1490, 2004, https://doi.org/10.4271/2004-01-1490.Also In
References
- Samenfink W. Albrodt H. Frank M. Gesk M. Melsheimer A. Thurso J. “Strategies to Reduce HC-Emissions During the Cold Starting of a Port Fuel Injected Gasoline Engine” SAE Paper 2003-01-0627
- Otto E. Albrecht F. Liebl J. “The Development of BMW Catalyst Concepts for LEV/ULEV and EU III/IV Legislations 6 Cylinder Engine with Close Coupled Main Catalyst” SAE Paper 980418 1998
- Pfalzgraf B. Firtzen M. Siebler J. Erdman H.-H. Audi AG “First ULEV Turbo Gasoline Engine - The Audi 1.8ltr 125kW 5-Valve Turbo” SAE Paper 2001-01-1350
- Maus W. Brueck R. “The Conical Catalytic Converter - Potential for Improvement of Catalytic Effectiveness” SAE 982633
- Mueller-Haas K. Webb C. Rieck J. “FTP and US06 Performance of Advanced High Cell Density Metallic Substrates as a Function of Varying Air/Fuel Modulation” SAE Paper 2003-01-0819
- Holy G. Brueck R. Hirth P. “Improved Catalyst Systems for SULEV Legislation; First Practical Experience” SAE Paper 2000-01-0500
- Pfalzgraf B. Rieger M. Ottowitz G. Audi AG “Close Coupled Catalytic Converter for Compliance with LEV/ ULEV and EGIII Legislation - Influence of Support Material, Cell Density and Mass on Emission Results” SAE 960261
- Marsh P. Acke F. Konieczny R. Brueck R. Hirth P. “Application Guideline to Define a Catalyst Layout for Maximum Catalytic Efficiency” SAE Paper 2001-01-0929