This content is not included in your SAE MOBILUS subscription, or you are not logged in.
A Calculation Methodology for Cam Overlap Optimization Towards Combustion Quality at Idle in IC SI Engines
ISSN: 0148-7191, e-ISSN: 2688-3627
Published September 16, 2003 by SAE International in United States
Annotation ability available
Engine stability at idle is an important factor that influences the behaviour of an I.C., S.I. engine, in terms of fuel efficiency, exhaust gas emissions and customer comfort. In particular, the increasing daily use of vehicles in urban traffic bestows more and more importance on the engine idle quality.
The engine idle quality is perceived by the user as the constancy of noise tone, low vibrations level and absence of sudden speed drop, noticeable on the steering wheel, gear shift lever, and seat .
Combustion characteristics play an essential role on the overall engine quality level at idle. It is important to have an estimation of the engine behaviour in this condition during the engine pre-development phase.
While the fluid-dynamic calculation codes mean the engine performance at full load can be predicted, but the modelling of part load and idle behaviour is very difficult.
The objective of the present work is to determine a simple methodology to calculate, during the pre-development phase, a geometrical parameter correlated to the combustion quality at idle. In particular this simple methodology, collecting together the valve lift curves and the valve geometry, means a geometrical parameter is determined which can be considered as a measure of the internal EGR rate within the combustion chamber.
Assuming a specific engine configuration, a good correlation has been found between this parameter, labelled “cam overlap total area” here, and the corresponding combustion quality level at idle, measured with indicating methods.
CitationFiorenza, R., Formisano, G., Petraglia, F., Strazzullo, L. et al., "A Calculation Methodology for Cam Overlap Optimization Towards Combustion Quality at Idle in IC SI Engines," SAE Technical Paper 2003-32-0040, 2003, https://doi.org/10.4271/2003-32-0040.
- Hoard J. Rehagen L. “Relating Subjective Idle Quality to Engine Combustion” SAE Paper No. 970035
- Poulos S.G. Heywood G.B. “The Effect of Chamber Geometry on Spark-Ignition Engine Combustion” SAE Paper No. 830334
- Bocchi G. Motori a Quattro Tempi 1987
- Di Martino U. Formisano G. Lucignano G. “Combustion Stability at Idle: A Non-Indicated Methodology For Analysis” SAE Paper No. 2003-01-0640
- Tortorella P. Torella E. “Ottimizzazione Sperimentale delle Prestazioni e della Combustione di un Motore FIRE di Nuova Generazione” Università di Napoli “Federico II” 2001
- Heywood J.B. Internal Combustion Engine Fundamentals McGraw Hill 1988
- Ferrari G. “Motori a combustione interna” Torino, il Capitello 1996