This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Effects of Friction on Bursting of Tubes in Corner Filling
Technical Paper
2003-01-0688
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Corner filling is a benchmark experiment in tube hydroforming. It was designed to gain knowledge pertinent of this new fabrication process. The corner filling benchmark has been widely used in the automotive and steel industries. Common sense as well as physical tests suggests that friction is an important parameter that affects the deformation of the tube and the bursting of the tubes. However, numerical simulations have yet to verify this fact. In this paper, the stress/strain states in the tube were computed using a finite element model. The dependence of bursting on friction for corner filling was estimated by using the forming limit diagram and a tensile-based failure criterion.
Authors
Topic
Citation
Chen, K., "The Effects of Friction on Bursting of Tubes in Corner Filling," SAE Technical Paper 2003-01-0688, 2003, https://doi.org/10.4271/2003-01-0688.Also In
References
- Ahmetoglu, M.A. Altan, T 1999 ‘Tube hydroforming - State-of-the-arts and future trends,’ SAE paper # 1999-01-0675 , in SAE publication SP-1435
- Ni, C.M. Peng, T.H. 2001 ‘Application of tubular hydroformed radiator support assembly to GM's new midsize SUVs,’ SAE paper # 2001-01-3089
- Chen, X.M. Dalton, G.M. 1999 ‘Sensitivity of tube hydroforming to friction and material properties,’ ISS Tube Hydroforming Symposium
- Songmene, V. 2001 ‘A comparison of high strength steel to mild steel in the corner fill hydroforming test,’ Final report for the project #235 205, Hydroforming Committee, Auto/Steel Partnership
- Chen, K.K. 2000 ‘A preliminary two-dimensional model of expansion of tubes in hydroforming,’ Sheet Metal Forming for the New Millennium , Proc.21 st Biennial Congress, IDDRG
- Kridli, G.T. Bao, T. Mallick, P.K. 2000 ‘Two Dimensional plane strain modeling of tube hydroforming,’ 11 Proceedings of the ASME
- Chen, K.K.
- Chen, K.K. 2002 ‘A bursting failure criterion for tube hydroforming,’ SAE Paper # 2002-01-0794
- Stoughton, T.B. 2000 ‘A general forming limit criterion for sheet metal forming,’ International Journal of Mechanical Sciences 42 1 27
- Tharrett, M.R. Stoughton, T.B. 2003 ‘Stretch-bend forming limits of 1008n AK steel,’ SAE Paper # 2003-01-1157