This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Investigations of the Gas Injection System on a HD-CNG-Engine
Technical Paper
2003-01-0625
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
1
In the present work investigations of a 7.8 liter-TC-IC-IVECO-CNG engine were performed with single point (SPI) *) and with multipoint (MPI) gas injection systems.
Three types of MPI injectors available on the market were compared for stationary and transient engine operation.
There are several advantages of MPI e.g. better possibility to equalize the air-fuel-ratio of the cylinders, optimization of the gas injection timing and of the gas pressure for different operating conditions.
With different injector types there are different optimum injection timings, due to different injection durations, but at the optimum conditions there is little difference in the combustion quality.
The injectors with higher flow rate can cause more λ-excursions in the dynamic response and with sudden changes of the gas pressure.
The gas pressure in the CNG-rail can be used to improve some operating conditions: lower pressure for low load, higher pressure for better dynamic response and for the full load operation.
Recommended Content
Authors
Citation
Czerwinski, J., Comte, P., and Zimmerli, Y., "Investigations of the Gas Injection System on a HD-CNG-Engine," SAE Technical Paper 2003-01-0625, 2003, https://doi.org/10.4271/2003-01-0625.Also In
References
- Czerwinski J. ; Comte P. ; Janach W. : Sequential Multipoint Mixture Preparation for Heavy-Duty Natural Gas Engines Report of project N° 3398.1, Swiss Commission for Technology and Innovation June 1998 University of Applied Sciences Biel- Bienne, Switzerland
- Czerwinski J. ; Comte P. ; Janach W. ; Zuber P. : Sequential Multipoint Trans-Valve-Injection for Natural Gas Engines SAE Technical Paper 1999-01-0565
- Czerwinski, J. ; Comte, P. : Trans-Valve-Injection and Influences of Gas Quality on a Natural Gas Engine Report of project N° 3961.2 Swiss Commission for Technology and Innovation (CTI) January 2000 University of Applied Sciences Biel-Bienne, Switzerland
- Czerwinski, J ; Comte, P. : Influences of Gas quality on a Natural Gas Engine SAE Technical Paper 2001-01-1194
- Bach Ch. Heeb N. Mattrel P. Mohr M. : Wirkungsorientierte Bewertung von Automobilabgasen EMPA Switzerland, Ber. Januar 1998
- Kubesh J. T. Podnar D. J. : Ultra Low Emissions and High Efficiency from an On-Highway Natural Gas Engine SAE Paper 981394 South west Research Institute
- Maier F. ; Müller P. ; Heck E. ; Langen P. : Erdgasmotorkonzept mit EZEV-Potential 58 1997 9
- Heck E. ; Langen P. : Potential of Natural Gas Powertrain to meet EZEV-Standards Intern. Wiener Motorensymposium 97
- Marquart K.-J. ; Fränkle G. ; Binder K. ; Lehmann J. : The development of the lean burn gas engine M906LAG with multipoint gas injection Daimler Chrysler AG Intern. Wiener Motorensymposium 99
- Havenith C. ; Meretei T. ; Romvari F. : Development of a RABA CNG Lean Burn Engine for Low Pollution City Bus Operation Intern. Wiener Motorensymposium 97
- Lazzarino, L. ; Froidevaux, V. : Potentiels d'optimisation des moteurs CNG pour des véhicules utilitaires lourds University of Applied Sciences Biel-Bienne, Switzer-land Oct. - Dec 2000
- Cantoni, L. ; Zimmerli, Y. : Influences du système de l'injection du gaz sur la combustion et les émissions d'un moteur CNG pour des véhicules utilitaires lourds University of Applied Sciences Biel-Bienne, Switzerland Oct. - Dec. 2001