This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
35 Engine Performance of the Small Compression Ignition Engine with DME Low Pressure Injection
Technical Paper
2002-32-1804
Annotation ability available
Sector:
Language:
English
Abstract
In the research of DME compression ignition engine, there are a lot of reports on the high fuel pressure systems which are used in the common-rail fuel injector and others for the DME mixture formation promotion. However, the initial development-cost of these fuel supply systems will be increased for small compression ignition engines. On the other hand, it has been understood that excellent thermal efficiency of DME compression ignition engine was obtained at the appropriate fuel injection timing by using the electronic controlled injector with low pressure injection. In this paper, the stabilization of combustion on DME compression ignition engine with low pressure injection was investigated for the influence of the fuel pressure and the combustion assistance with homogeneous charge. As the result, it was clarified that the fuel mixture formation was promoted due to the active contact between the fuel molecules and the oxygen molecules, because of the reinforcement of the fuel penetration and the increase of the stir actions which included the turbulance of combustion and swirl flow.
Authors
Topic
Citation
SUZUKI, T., YONETANI, H., and FUKUTANI, I., "35 Engine Performance of the Small Compression Ignition Engine with DME Low Pressure Injection," SAE Technical Paper 2002-32-1804, 2002.Also In
References
- Suzuki T. Yonetani H. Fukutani I. “Influence of air flow in cylinder on DME compression ignition engine” JSAE proceedings 20015091 2001
- LI Jun et al. “Fundamental Study of DME Injection By an Electromagnetic Injector” JSAE proceedings 20015333 2001
- Suzuki T. Yonetani H. Fukutani I. “The applicability of low-pressure injection to DME compression ignition engine” JSAE proceedings 20005446 2000
- Suzuki T. Yonetani H. Fukutani I. “The applicability of dimethyl ether (DME) to compression ignition engine” JSAE proceedings 9838912 1998
- Suzuki T. Yonetani H. Fukutani I. “Combustion Characteristics of A Compression Ignition Engine with DME” ASME paper 2000-ICE-290 2000
- Suzuki T. Yonetani H. Matsuoka S. “EGR characteristic of compression ignition engine with DME” SME RC170 final report 2001
- Igarashi T. Iida N. “Auto Ignition and Combustion of DME and n-Butane/Air Mixtures in Homogeneous Charge Compression Ignition Engine” JSME paper No.97-1198 1998
- Konno M. et al. “Investigation of the Combustion Process a DI CI Engine Fueled with Dimethyl Ether” SAE paper No. 2001-01-3504 2001