This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Characterization of Pressure Waves in HCCI Combustion
Technical Paper
2002-01-2859
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The objective of this work was to understand the physics of combustion-generated pressure waves from Homogeneous Charge Compression Ignition combustion and the resulting audible noise that is produced. Experiments were performed with a single-cylinder engine operating in both SI and HCCI combustion modes, and comparisons were made between the pressure waves generation from the two types of combustion. Cylinder pressure oscillation amplitudes at the first circumferential mode frequency (5 to 6 kHz) generated in HCCI combustion are 5 to 10 times higher than those generated in SI knocking combustion without an undue increase in audible engine noise. Frequency analysis of the data showed that in knocking combustion a larger portion of the wave energy is contained within the higher order resonance modes. Cylinder block vibration measurements indicate that the cylinder liner significantly dissipates the wave energy below 8 kHz.
A correlation for the pressure wave intensity was developed and used to successfully correlate all of the experimental data. The correlation was applied to data obtained from the literature from a HCCI engine operated under supercharged conditions, and was able to successfully explain the experimental observation that with higher boost levels the engine could withstand higher rates of pressure rise without an increase in audible engine noise.
Recommended Content
Authors
Citation
Eng, J., "Characterization of Pressure Waves in HCCI Combustion," SAE Technical Paper 2002-01-2859, 2002, https://doi.org/10.4271/2002-01-2859.Also In
References
- Christensen, M. Johansson, B. Amneus, P Mauss, F. “Supercharged Homogeneous Charge Compression Ignition” SAE 980787 1998
- Hirose, A. Lonngren, K. E. Introduction to Wave Phenomena John Wiley and Sons 1985
- Eriksson, L. J. “Silencers” Noise Control in Internal Combustion Engines Baxa, D. E. John Wiley & Sons 1982
- Hickling, R. Kamal, M. “Engine Noise: Excitation, Vibration and Radiation” International Symposium on Engine Noise Plenum Press 1982
- Scholl, D. Davis, C. Russ, S. Barash, T. “The Volume Acoustic Modes of Spark-Ignited internal Combustion Engines” SAE 980893 1998
- Leppard, W. R. “Individual-Cylinder Knock Occurrence and Intensity in Multicylinder Engines” SAE 820074 1982
- Tolstov, G. P. Fourier Series Dover Publications, Inc. 1962
- Tipler, P. A. Physics Worth Publishers 1982
- Randolph, A. L. “Cylinder Pressure Transducer Mounting Techniques To Maximize Data Accuracy” SAE 900171 1990
- Horowitz, P. Hill, W. The Art of Electronics Cambridge University Press 1980
- Andon, J. Marks, C. “Engine Roughness - The Key to Lower Octane Requirement” SAE Paper 647A 1963
- Schmillen, K. P. Rechs, M. “Different Methods of Knock Detection and Knock Control” SAE 910858 1991
- Lee, J. Hwang, S. Lim, J. Jeon, D. Cho, Y. “A New Knock-Detection Method Using Cylinder Pressure, Block Vibration and Sound Pressure Signals From a SI Engine” SAE 981436 1998
- Thien, G. E. “A Review of Basic Design Principles For Low-Noise Diesel Engines” SAE 790506 1979