This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Surface Treatment of Gears Using the Pulsed Plasma Ion Nitriding Technology
Technical Paper
2002-01-1362
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
There has been much discussion regarding the surface treatment of gear power transmission systems using the nitriding process. Much of the past discussions have centered around the suitability of the process results because of the potential for high surface hardness results, and the impact value of the nitrided surface.
This presentation will discuss:
- Materials for gears for nitriding
- Process control
- Process method selection
- Testing and interpretation of results
With these objectives in mind it is the intention of the writer to demonstrate the advantages of the nitriding process for the surface treatment of gears.
Recommended Content
| Technical Paper | Advances in P/M Gear Materials |
| Ground Vehicle Standard | Single Tooth Gear Bending Fatigue Test |
| Technical Paper | Development of Ultra Fine Grain Steel for Carburizing |
Authors
Topic
Citation
Pye, D., "Surface Treatment of Gears Using the Pulsed Plasma Ion Nitriding Technology," SAE Technical Paper 2002-01-1362, 2002, https://doi.org/10.4271/2002-01-1362.Also In
References
- Floe, Carl F. A Study Of The Nitriding Process Effect Of Ammonia On The Case Depth And Structure American Society Of Materials Transaction 32 1944
- Pye D. The Steel Heat-Treatment Handbook Chapter On Nitriding Totten & howes Marcell decker NY 1997
- ASTM Quality Assurance Grain Size Testing
- 1998