This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Continuous Improvement Efforts in Wire Bonding
Technical Paper
2002-01-0894
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Concerns with stripping and soldering copper magnet wire in ignition coils and other related products have led to the investigation of an alternative product and process design, microjoining. This paper describes the initial development occurring during the improvement phase of a Six Sigma project. The use of microjoining with a folded over welding tab terminal design coupled with a parallel gap welding process is developed as a suitable method for joining a tin plated brass terminals to the 0.65mm magnet wire without prior removal of the polyesterimide over-coated polyamideimide insulation.
Authors
Citation
Lynch, D., Fleischmann, J., and Duff, W., "Continuous Improvement Efforts in Wire Bonding," SAE Technical Paper 2002-01-0894, 2002, https://doi.org/10.4271/2002-01-0894.Also In
References
- Riches, S.T. January 1994 “Techniques for Welding Fine Insulated Cu Wire without Prior Removal of Insulation,” TWI Journal 3 1 155 176
- Ely, Kevin Dr. 1997 “Small Scale Resistance Welding,” The Ohio State University Columbus, Ohio 3 4
- Dawes, CJ Johnson, K.I. Scott, M.H. 1980 “Ultrasonic Ball/Wedge Bonding of Aluminum Wires,” ElectroComponent Science and Technology 7 1-3 119 124