This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Influence of the Material Model on the Stress-Based Forming Limit Criterion
Technical Paper
2002-01-0157
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The stress-based forming limit criterion has recently been shown to exhibit no significant dependence on strain path for a wide range of materials. This paper describes the effect of material models on the definition of the stress-based forming limit criterion. It is shown that although the shape of the forming limit curve in stress space is sensitive to the type of material model used, the degeneracy of the path dependent strain-based curves to a single curve in stress space shows little sensitivity to the material model. Consequently, the stress based forming limit criterion is shown to provide a more practical and robust measure of forming severity than is possible using the conventional forming limit diagram.
Recommended Content
Topic
Citation
Stoughton, T., "The Influence of the Material Model on the Stress-Based Forming Limit Criterion," SAE Technical Paper 2002-01-0157, 2002, https://doi.org/10.4271/2002-01-0157.Also In
References
- Keeler, S. P. Backhofen, W. A. “Plastic Instability and Fracture in Sheet Stretched Over Rigid Punches,” ASM Transactions Quarterly 56 25 48 1964
- Goodwin, G. M. “Applications of Strain Analysis to Sheet Metal Forming in the Press Shop,” SAE paper, No. 680093 1968
- Graf, A. F. Hosford, W. F. “Calculations of forming limit diagrams for changing strain paths” Met. Trans. A 24 2497 2501 1993
- Kleemola, H. J. Pelkkikangas, M. M. “Effect of predeformation and strain path on the forming limits of steel, copper, and brass,” Sheet Metal Industries 63 591 599 1977
- Arrieux, R. Bedrin, C. Boivin, M. “Determination of an intrinsic forming limit stress diagram for isotropic metal sheets Proceedings of the 12 th Biennial Congress IDDRG 61 1982
- Stoughton, T. B. “A General Forming Limit Criterion For Sheet Metal Forming,” Int. J. of Mech. Sci. 42 1 27 2000
- Ghosh, A. K. Laukonis, J. V. “The influence of strain path changes on the formability of sheet steel,” Sheet Metal Forming and Energy Conservation 1976
- Hill, R. Proceedings of the Royal Society 193A 281 297 1948
- Logan, R. Hosford, W. F. Int J. of Mech. Sci. 22 419 1980
- Barlat et al. “Yield function development for aluminum alloy sheet,” J. Mech. Phys. Solids 45 1727 1997
- Stoughton, T. B. “A non-associated flow rule for sheet metal forming,” Int. J. of Plasticity