This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Finite Element Analysis of a Piston Ring for Assembly Load Measurements and Interface Stresses
ISSN: 0148-7191, e-ISSN: 2688-3627
Published November 01, 2001 by The Automotive Research Association of India in India
Annotation ability available
Event: SIAT 2001
The paper presents the results of a Finite Element study of a piston ring under assembly load in terms of the induced stresses and ring gap. The study includes the stress analysis at the interface between the coating and substrate of the ring for various lay designs. The information from the analysis would serve to reduce the design-performance testing cycle time and be useful in the development of coating techniques.
CitationKurbet, S., Krishnakumar, R., and Gowrishankar, N., "Finite Element Analysis of a Piston Ring for Assembly Load Measurements and Interface Stresses," SAE Technical Paper 2001-28-0053, 2001, https://doi.org/10.4271/2001-28-0053.
- Murray Edward J. 1979, “Piston Rings for Passenger Car Engines” SAE 790698, 2420-2435
- Buran U.Dipl._Ing., Mader H. _Ch.Dipl._Ing. and Moorsbach M.Dr. “Plasma Sprayed Coating for Piston Rings; State of Development and Application Potential. Goetze AG _5093 BORSHED W. GERMANY
- I-DEAS Master Series, Structural Dynamic Research Corporation.2000 Eastman Dr.Milford, OH 45150 By Lawry Mark H.
- ABAQUS/Explicit Version 5.8-1.Hibbitt, Karrisson& Sorensen,Inc. Pawtucket, RI 02860-4847 U.S.A
- Dock G. E. 1985,“Trends in Piston Ring Development for High Output Diesel Engines” SAE 851193, 5.1-5.14
- BeyerH. and Neuhauser H. J., GOETZE Technical Paper “K 20”
- Demarchi Valmir, COFAP “Influence of top rings lower peripheral edge chamfer on blow-by and oil consumption.” 49-51