This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Cycle to Cycle Diesel Combustion Characterisation During Engine Transient Operation
Technical Paper
2001-01-3262
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In the paper is described how to characterise the combustion process of a high speed turbocharged direct injection diesel engine (HSDI) during a transient process, which consists on a full load acceleration at constant engine speed, known as load transient. The combustion characterisation is based on the cycle to cycle combustion analysis and the Rate of Heat Release calculation (RoHR).
The information presented in the paper includes, the transient recorded data at three different engine speeds joint with information about transducers characteristics and measurement frequencies. The post-processing of the obtained information and its synchronization is described in detail; a protocol of the process is finally obtained. The RoHR of every transient cycle is calculated and shown as final objective of the work. To conclude, relevant information about mechanical efficiency, maximum in-cylinder pressure, diesel combustion phases starting and duration is also obtained from the transient process analysis by means of a combustion diagnostic code.
Authors
Citation
Galindo, J., Bermúdez, V., Serrano, J., and López, J., "Cycle to Cycle Diesel Combustion Characterisation During Engine Transient Operation," SAE Technical Paper 2001-01-3262, 2001, https://doi.org/10.4271/2001-01-3262.Also In
References
- Zelenka, P. Aufinger, H. Walter, R. Wolfgang, C. Cooled EGR - a key technology for future efficient H: D: diesels SAE paper 980190 1998
- Dekker, H.J. Sturm, W.L. Simulation and control of a H. D. diesel engine equipped with a new EGR technology SAE paper 960871 1996
- Lüders, H. Stommel, P. Diesel exhaust treatment-new approaches to ultra low emission diesel vehicles SAE paper 1999-01-0108 1999
- Walsh, M.P. Global trends in diesel emissions control - A 1999 update SAE paper 1999-01-0107 1999
- Ramos, J.I. Internal Combustion Engine Modelling Hemisphere Publishing 1989
- Horlock, J.H. Winterbone, D.E. The thermodynamics and gas dynamics of internal combustion engines II CLARENDON PRESS 0198562128 Oxford 1986
- Watson, N. Marzouk, M. A non-linear digital simulation of turbocharged diesel engines under transient conditions SAE paper 770123 1977
- Watson, N. Transient performance simulation and analysis of turbocharged diesel engines SAE paper 810338 1981
- Schorn, N. Pischinger, F. Schulte, H. Computer simulation of turbocharged diesel engines under transient conditions SAE paper 870723 1987
- Winterbone, D.E. Yoshitomi, M. The accuracy of calculating wave action in engine intake manifolds SAE paper 900677 1990
- Watson, N. Computers in diesel engine turbocharging system design IMechE 1987
- Benajes, J. Reyes, E. Galindo, J. Peidró, J. Predesign model for intake manifolds in internal combustion engines SAE paper 970055 1997
- Benajes, J. Reyes, E. Bermúdez, V. Serrano, JR. Pre-design criteria for exhaust manifolds in I.C. automotive engines SAE paper 980783 1998
- Payri F. Reyes E. Galindo J Analysis and Modelling of the fluid-dynamic effects in branched exhaust junctions of I.C.E. International Journal for Gas Turbine and Power: Transactions of the ASME 123 1 197 203 2001
- Payri, F. Benajes, J. Chust, M.D. 162 17 23
- Benajes, J. Reyes, E. Lujan, J.M. Modeling study of the scavenging process in a turbocharged Diesel engine with modified valve operation Proceedings of the IMechE. Part C: Journal of Mechanical engineering Science 210 1996
- Payri, F. Benajes, J. Galindo, J. One-dimensional fluid-dynamic model for catalytic converters in automotive engines SAE paper 950785 1995
- Payri, F. Benajes, J. Reyes, M. Modelling of supercharger turbines in internal-combustion engines International Journal of Mechanical Science 38 8-9 835 869 1996
- Payri, F. Reyes, E. Serrano, JR. A model for load transients of turbocharged diesel engines SAE paper 1999-01-0225 1999
- Benajes, J. Luján, JM. Serrano, JR. Predictive modelling study of the transient load response in a Heavy-Duty turbocharged diesel engine SAE paper 2000-01-0583 2000
- Payri, F. Galindo, J. Serrano, JR. Variable geometry turbine modelling and control for turbocharged diesel engines transient operation Proceedings of THIESEL 2000. Thermofluidynamic Processes in Diesel Engines 84-7721-910-9 173 189 2000
- Serrano, J.R. Analysis and modelling of the load transient in turbocharged diesel engines Univ. Politécnica de Valencia Spain 1999
- Rodriguez, A. Comparative analysis and synthesis of the turbocharged direct injection diesel engines transient response Univ. Politécnica de Valencia Spain 2001
- Santos, R. A study on the available energy in the exhaust gases of diesel engines Univ. Politécnica de Valencia Spain 1999
- Watson, N. Pilley, A.D. Marzouk, M.A. Combustion correlation for diesel engine simulation SAE paper 800029 1980
- Winterbone, D.E. Tennant, D.W.H. The variation of friction and combustion rates during diesel engine transients” SAE paper 810339 1981
- Assanis, D. Filipi, Z. Fiveland, S. Syrimis, M. A Methodology for cycle-by-cycle transient heat release analysis in turbocharged direct injection diesel engine SAE paper 2000-01-1185 2000
- Payri, F. Armas, O. Desantes, R. Leiva, A. Thermodynamic model for the experimental diagnosis of the combustion process in D.I. diesel engines La Habana. Cuba 1997
- Lapuerta, M. Armas, O. Hernández, J.J. Diagnostic of DI Diesel combustion from in-cylinder pressure signal by estimation of mean thermodynamic properties of the gas 19 513 529 Applied Thermal Engineering Oxford, UK 1999
- Lapuerta, M. Armas, O. Hernández, J.J. Effect to the Injection Parameters of a Common Rail Injection System on Diesel Combustion through Thermodynamic Diagnosis SAE paper 1999-01-0194 1999
- Lapuerta, M. Armas, O. Bermúdez, V. Sensitivity of Diesel engine thermodynamic cycle calculation to measurement errors and estimated parameters 20 843 861 Applied Thermal Engineering Oxford, UK 2000
- Desantes, JM. Arregle J. Pastor, JV Influence of the fuel characteristics on the injection process in a D.I. Diesel engines SAE paper 980802 1998
- Armas, O. Experimental diagnosis of the combustion process in direct injection diesel engines Univ. Politécnica de Valencia Spain 1998
- Hohenberg G. Definition und Eigenschaften des thermodynamischen Verlustwinkels von Kolbenmashinen April 1976
- Woschni, G.A. Universally applicable equation for instantaneous heat transfer coefficient in the internal combustion engine SAE paper 670931 1967
- Law, CK. Williams, FA. Kinetics and convection in the combustion of alkane droplets Combustion and Flame 19 3 393 406 1972
- Ranza, WE. Marshall, WR. Evaporation from Drops Chemical Engineering Progress 8 141 146 173 180 1952
- Turns, S.R. An introduction to combustion Concepts and applications McGraw-Hill 1996
- Faeth, GM. Current status of droplet and liquid combustion Progress in Energy and Combustion Science 3 191 224 1977
- Heywood, J.B. Internal Combustion Engine Fundamentals McGraw-Hill 1988
- Reid, RC. Prausnitz, JM. Poling, BE. The properties of gases and liquids McGraw-Hill Fourth 1986
- Tinaut, FV. Benajes, JV. Lapuerta, M. Fuel evaporation simulation in a direct injection diesel engine 2 33 1988
- Hiroyasu, H. Kadota, T. Arai, M. Development and use of a spray combustion modelling to predict diesel engine efficiency an pollutant emissions Bulletin of the JSME 26 214 569 575 1983
- Payri, F. Tinaut, F.V. 2 193 199 1989
- Way, R.J.B. Methods for the Determination of Composition and Thermodynamic Properties of Combustion Products for Internal Combustion Engine Calculations Proc. Inst. Mech. Engrs. 190 60 76 687 697 1977
- Kee, R.J. Rupley, F.M. Miller, J.A. The Chemkin Thermodynamic Data Base Sandia Report, SAND87-8215B 1991
- Chen S.K. Flynn P. Development of a compression ignition research engine SAE paper 650733 1965