This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Optimum Engine Mounting Layout by Genetic Algorithm
Technical Paper
2001-01-2810
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In this study, the genetic algorithm so called GA is newly applied for the optimization of many engine mounting parameters, calculations of stiffness matrix and inverse matrix to obtain 6 degrees of freedoms displacements at mounting points and a center of gravity. As a result, the optimized result could be shortly obtained in a minute, and an inexperienced engineer could easily make the optimum engine mounting layout, which can satisfy the vibration isolation and the non-interference in an engine compartment.
Recommended Content
Technical Paper | A Computerized Optimization Method Of Engine Mounting System |
Technical Paper | The Optimum Design of Engine Mounting |
Technical Paper | Analytical Method for Efficient Development of Optimal Fixed-Point Software and its Application |
Authors
Citation
Sakai, T., Iwahara, M., Shirai, Y., and Hagiwara, I., "Optimum Engine Mounting Layout by Genetic Algorithm," SAE Technical Paper 2001-01-2810, 2001, https://doi.org/10.4271/2001-01-2810.Also In
References
- SAKAI, T. IWAHARA, M. “The Optimum Designing of Engine Mounting for Heavy Duty Vehicle(1 st Report, The Theoretical Study of The Engine Mounting Function) JSME paper, 65-631 1999 3 887 894
- SAKAI, T. “The Optimum Designing of Engine Mounting for Heavy Duty Vehicle(2 nd Report, The Optimization of Coupled Vibration Reduction between Lateral and Rolling Mode)” JSME paper, 65-633 1999 5 1757 1763
- SAKAI, T. TAKANO, Y. IWAHARA, M. “The Optimum Designing of Engine Mounting for Heavy Duty Vehicle(3 rd Report, The Analysis of Mechanism concerning Engine Exciting Force and Rolling Couple of Forces) JSME paper, 65-633 1999 5 1764 1771
- SAKAI, T. IWAHARA, M. “The Optimum Designing of Engine Mounting for Heavy Duty Vehicle(4 th Report, The Optimization of Supporting Points of in-line 6 Cylinders Engine by the Exciting Torque) JSME paper, 65-639 1999 11 4423 4430
- SAKAI, T. TAKANO, Y. IWAHARA, M. “The Optimum Design of Engine Mounting” SAE paper No. 982825 1998
- SAKAI, T. IWAHARA, M. “The Optimum Design of Engine Mounting by Dynamic Analysis” SAE paper No. 1999-01-3717
- TOHARA, H. et al. “The Vibration Isolation Rubber” Gendai-kougakusha 1975
- TOHARA, H. et al. “The New Vibration Isolation Rubber” Gendai-kougakusha 1998
- NAGAMATSU, A et al. “The Hand Book of Modal Analysis” Corona-sha 2000
- SANNOMIYA, N. et al. “Genetic Algorithm and Optimization” Asakura-shoten 1998
- SAKAWA, M et al. “Genetic Algorithm” Asakura-shoten 1996