This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Influence of Mixture Fluctuations on Combustion in Direct Injection Spark Ignition Engines Simulations
Technical Paper
2001-01-1226
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2001 World Congress
Language:
English
Abstract
Modelling small and large scale fluctuations of fuel distribution is of high interest for stratified direct injection spark ignition (DISI) engines. Homogeneous combustion models need to be extended or replaced in order to account for these fluctuations. They are presently neglected in most engine simulations. Effects of mean fuel/air equivalence ratio gradient have been recently included in previous homogeneous mixture approaches.
To account for local fluctuations of mixture composition, the new model ECFM-Z has been developed on the basis of recent Direct Numerical Simulation results and Coherent Flame Surface modelling. The model has been implemented in a CFD code (KMB) The influence of mixture fraction is integrated in the Extended Coherent Flame Surface combustion model. The model is based on a conditional approach. Unburnt hydrocarbons produced by lean flame local extinctions are taken into account.
The model ECFM-Z is applied to investigate mixture fluctuation effects in a wide spacing, DISI engine running under stratified operating conditions. A typical stratified combustion parameter, the ignition timing, is varied. Accounting for the local fluctuations in mixture composition modifies heat release estimation. Effects of partial quenching and mass burning rate modelling on the combustion efficiency are revealed.
Recommended Content
Authors
Citation
Hélie, J., Duclos, J., Baritaud, T., Poinsot, T. et al., "Influence of Mixture Fluctuations on Combustion in Direct Injection Spark Ignition Engines Simulations," SAE Technical Paper 2001-01-1226, 2001, https://doi.org/10.4271/2001-01-1226.Also In
References
- AMSDEN A. O'ROURKE P. BUTLER T. A computer program for chemically reactive flows with sprays Technical Report LA-11560-MS Los Alamos Nat. Lab. 1989
- ANGELBERGER C. POINSOT T. DELHAYE B. Improving near-wall combustion and wall heat transfer modeling in si engine computations SAE technical paper 972881 1997
- ARCOUMANIS C. HULL D.R. WHITELAW J.H. An approach to charge stratification in lean-burn spark-ignition engines SAE technical paper 941878
- BARITAUD T.A. DUCLOS J.M. FUSCO A. Modeling turbulent combustion and pollutant formation in stratified charge si engines 26th Symp. (Int.) on Combustion The Combustion Institute Pittsburgh, PA 2627 2235 1996
- BARITAUD T.A. HEINZE T.A. Gasoline distribution measurements with plif in a si engine SAE technical paper 922344 1992
- BLINT R. The relation of the laminar flame width to flame speed Combust. Sci. Technol. 49 1986
- CANDEL S.M. VEYNANTE D. LACAS F. MAISTRET E. DARABIHA N. POINSOT T. Coherent flame model: application and recent extensions Larrouturou B. Recent advances in combustion modelling World scientific 1990
- CANT R.S. POPE S.B. BRAY K.N.C. 23rd Symp. (Int.) on Combustion The Combustion Institute Pittsburgh, PA 809 815 1990
- CASTAGNE M. CHEVE E. DUMAS J.-P. HENRIOT S. Advanced tools for analysis of gasoline direct injection engines SAE technical paper 2000-01-1903 2000
- CUENOT B. HAWORTH D. POINSOT T. BLINT R. Numerical simulation of turbulent propane-air combustion with nonhomogeneous reactants: initial results proceedings of the summer program 1998 Center for Turbulent Research - Stanford University 1998
- DESCHAMPS B. RICORDEAU V. MAUNOURY B. Rapport GSM O.2.1 1997
- DRAKE M.C. FANSLER T.D. FRENCH D.T. Crevice flow and combustion visualization in a direct-injection spark-ignition engine using laser imaging techniques SAE technical paper 952454 1995
- DUCLOS J.-M. Technical report IFP 2000
- DUCLOS J.M. ZOLVER M. 3d modeling of intake, injection and combustion in a di-si engine under homogeneous and stratified operating conditions The Fourth International Symposium COMODIA 98 335 340 1998
- DUCLOS J.M. ZOLVER M. BARITAUD T. 3d modeling of combustion for di-si engines Oil and Gas Sci. and tech. 54 259 264 1999
- ESWARAN V. POPE S.B. Direct numerical simulations of the turbulent mixing of a passive scalar Phys. Fluids A 3 31 1988
- FUJIMOTO M. NISHIDA K. HIROYASU H. TABATA M. Influence of mixture stratification pattern on combustion characteristics in a constant-volume combustion chamber SAE technical paper 952412 1995
- GHANDHI J.B. BRACCO F.V. Mixture preparation effects on ignition and combustion in a direct-injection sapark-ignition engine SAE technical paper 962013 1996
- HABCHI C. TORRES A. A 3D multi-block structured version of the Kiva-2 code ELSEVIER First European CFD conference proceedings 1 502 512 1992
- HELIE J. TROUVE A. Turbulent flame propagation in partially premixed combustion 27th Symp. (Int.) on Combustion The Combustion Institute Pittsburgh, PA 1998
- HELIE J. TROUVE A. A modified coherent flame model to describe turbulent flame propagation in mixtures with variable composition 28th Symp. (Int.) on Combustion The Combustion Institute Pittsburgh, PA 2000
- HELIE J. TROUVE A. A modified coherent flame model for turbulent combustion with mixture fluctuations Combustion and Flame
- KOLMOGOROV A.N. PETROVSKI I.G. PISKUNOV N.S. Mjul Moscosukovo Gos Univ 1 1 72 1937
- KUWAHARA K. ANDO H. Analysis of barrel-stratified lean-burn flame structure by two-dimensional chemiluminescence measurement JSME international journal 37 3 1994
- MAGNUSSEN B.F. HJERTAGER B.H. On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion 16th Symp. (Int.) on Combustion The Combustion Institute Pittsburgh, PA 1976
- MARBLE F. BROADWELL J. The coherent flame model of non-premixed turbulent combustion Technical Report TRW-9-PU Purdue University 1977
- MENEVEAU C. POINSOT T. Stretching and quenching of flamelets in premixed turbulent combustion Combust. Flame 86 311 332 1991
- METGHALCHI M. KECK J.C. Laminar burning velocity of propane-air mixtures at high temperature and pressure Combustion and Flame 38 1980
- MORIYOSHI Y. MORIKAWA H. KAMIMOTO T. HAYASHI T. Combustion enhancement of very lean premixture part in stratified charge conditions SAE technical paper 962087 1996
- MOUQALLID M. LECORDIER B. TRINITE M. High speed laser tomography analysis of flame propagation in a simulated internal combustion engine - applications to non-uniform mixture SAE technical paper 941990 1994
- OHYAMA Y. OHSUGA O. KUROIWA H. Study on mixture formation and ignition process in spark ignition engine using optical combustion sensor SAE technical paper 901712 1990
- PLACKMANN J. D. KIM T. GHANDHI J.B. The effects of mixture stratification on combustion in a constant combustion vessel SAE technical paper 980159 1998
- REBOUX J. PUECHBERTY D. DIONNET F. Study of mixture inhomogeneities and combustion developement in a si engine using a new approch of laser induced fluorescence (farlif) SAE technical paper 961205 1996
- TORRES A. HENRIOT S. 3d modeling of combustion in lean burn four-valve engines: influence of intake configuration Comodia 94 151 156 1994
- VEYNANTE D. LACAS F. MAISTRET E. CANDEL S.M. Coherent flame model for non-uniformly premixed turbulent flames Turbulent Shear Flows 7 1991
- WILLIAMS F.A. Combustion theory Benjamin Cummings 1985
- WOLFF D. SCHLUTER H. BEUSHAUSEN V. ANDRESEN P. Quantitative determination of fuel air mixture distributions in an internal combustion engine using plif of acetone Ber. Bunsenges. Phys. Chem. 97 12 1738 1741 1993
- ZEMAN O. LUMLEY J.L. J. Atmos. Sci. 33 1974 1988 1976
- ZHAO F.-Q. KADOTA T. TAKEMOTO T. Mixture strengh measurements in the combustion chamber of si engine via rayleigh scattering (ensemble-averaged mean concentration and cyclic variation of temporal mean concentration near the spark plug) JSME international journal 37 1 1994