This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
An Experimental Study on Fuel Behavior During the Cold Start Period of a Direct Injection Spark Ignition Engine
Technical Paper
2001-01-0969
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2001 World Congress
Language:
English
Abstract
An experimental study was carried out in order to reduce engine-out HC emissions from a direct injection spark ignition (DISI) engine during the cold start period. The objectives of this study were to investigate the fuel behavior quantified with an analytic method and to propose some practical techniques to reduce the cylinder-wetting fuel volume and engine-out HC emissions.
Compared to the MPI (Multi Port Fuel Injection) engine, required fuel volume for DISI engine was reduced during the cold start because intake port wall-wetting was not generated. On the other hand, a large volume of cylinder wetting fuel resulted in engine-out HC emissions. Injection timing, atomization and vaporization of injected fuel affected the cylinder-wetting fuel volume. Above all, Injection of the heated fuel provided good results.
In summary, engine-out HC emissions from DISI engine was reduced compared to that of MPI engine during the cold-start period.
Recommended Content
Authors
Topic
Citation
Koga, N., Miyashita, S., Takeda, K., and Imatake, N., "An Experimental Study on Fuel Behavior During the Cold Start Period of a Direct Injection Spark Ignition Engine," SAE Technical Paper 2001-01-0969, 2001, https://doi.org/10.4271/2001-01-0969.Also In
References
- Kume T. “Combustion Control Technologies for Direct Injection SI Engine” SAE Paper 960600
- Harada J. “Development of Direct Injection Gasoline Engine” SAE Paper 970540
- Kanda M. “Application of a New Combustion Concept to Direct Injection Gasoline Engine” SAE Paper 2000-01-0531
- Takeda K. “Mixture Preparation and HC Emissions of a 4-Valve Engine with Port Fuel Injection During Cold Starting and Warm-up” SAE Paper 950074
- Stanglamaier R.H. “The Effect of In-cylinder Wall Wetting Location on the HC Emissions from SI Engines” SAE Paper 1999-01-0502
- Ohyama Y, “Mixture Formation During Cold Starting and Warm-up in Spark Ignition Engines” SAE Paper 960065
- Saito K. “A New Method to Analyze Fuel Behavior in a Spark Ignition Engine” SAE Paper 950044
- Tabaczynski R. “Time-Resolved Measurements of Hydrocarbon Mass Flowrate in the Exhaust of a Spark Ignition Engine” SAE Paper 720112