This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Low Noise Intake System Using Non-Helmholtz Type Resonator
Technical Paper
2000-05-0313
Annotation ability available
Sector:
Event:
Language:
English
Abstract
The intake noise of an automobile induced by firing of an engine accompanies acoustic resonance of ducts of an intake system. Conventionally, the adoption of the Helmholtz type resonator was one of possible ways to eliminate the booming noise due to acoustic resonances of air ducts. Although the Helmholtz type resonator is convenient to attenuate the intake noise of an automobile, the usage of the Helmholtz type resonator requires cost increase or big engine room space. Therefore, reduction of the number of the resonators or the volume of the resonators is essential to increase the value of an automobile. To meet these requirements, other types of resonator are suggested instead of the Helmholtz type resonator. The effectiveness of the suggested resonators is compared considering noise reduction ability, effect to the engine performance and size of each resonator.
Recommended Content
Technical Paper | Vehicle Sound Package - Art or Science? |
Technical Paper | Study of Coupling Behavior of Acoustic Cavity Modes to Improve Booming Noise in Passenger Vehicles |
Technical Paper | Blower Motor Whining Noise - A Case Study |
Citation
Jung, B., Ko, U., Lim, J., Lee, C. et al., "Development of a Low Noise Intake System Using Non-Helmholtz Type Resonator," SAE Technical Paper 2000-05-0313, 2000.Also In
References
- Sacks Mal P. Hackney Steve 1988 “Perfomance of Acoustic Components for Engine Induction Systems” SAE 880081 1 11
- Schuchardt Mark E. Dear Terrence A. 1993 “An Air Induction System for a Four-Cylinder Engine: Design, Noise Control and Engine Efficiency” SAE 931317 433 439
- Nishio Yoshitako Kuroda Osamu “New Approach to Low-Noise Air Intake System Development” SAE Paper No. 911042
- Kouichirou Kuratam Kazuyuki Miyake 1993 “Experimental Acoustic Analysis of the Intake and Exhaust System to Predict Insertion Loss and Engine Performace” SAE Paper No. 931903
- Cummings A. Kirby R 1998 “Low Frequency Sound Transmission in Ducts with Porous Walls” INTERNOISE98
- Ih J. G. Lee B. H. 1987 “Theoretical Prediction of The Transmission Loss of Circular Reversing Chamber Mufflers” Journal of Sound and Vibration 112 2 261 271
- 1977 “Finite Element Acoustical Analysis of Complex Muffler Systems With and Without Wall Vibrations” Noise Control Engineering 86 92
- Cheng, C. Y. R. Wu, T. W. 1999 “Exhaust Muffler Design and Analysis Using A Boundary Element Method Based Computer Program” Proceedings of the 1999 Noise and Vibration Conference Vol. 89 95
- Prasad, M. G. Crocker, Malcolm. J. 1981 “Evaluation of four-pole parameters for a straight pipe with a mean flow and a linear temperature gradient” J. Acoust. Soc. Am. 69 4 916 921
- Seybert A. F. 1977 “Experimental determination of acoustic properties using a two-microphone random-excitation technique” J. Acoust. Soc. Am. 61 5 1362 1370
- Seybert A. F. 1988 “ Two-sensor methods for the measurement of sound intensity and acoustic properties in ducts” J. Acoust. Soc. Am.
- Lee C. M. Park S. J. Lim H. J. Han S. S. 1998 “Development of a Software for the Acoustic Analysis of Car Exhaust System Using the Hybrid Method” INTERNOISE98