This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Fuel Design Concept for Low Emission in Engine Systems
Technical Paper
2000-01-1258
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2000 World Congress
Language:
English
Abstract
In previous our work, we revealed that the flash boiling process could improve remarkably the spray atomization for the pure substance-single component fuel in relation to the port-injected S.I. engines. Then, we applied this flash boiling spray to the Diesel spray process by the use of the two phase region formed between liquefied CO2 and n-Tridecane as the first step of fuel design concept. And the promoted atomization properties could be obtained in this mixed fuel concept. Further, we could obtain the simultaneous reduction of NO and soot emissions in Diesel engine exhaust due to the spray internal EGR effect and reburning of soot. As the second step, we proposed a novel fuel design concept for low exhaust emission and combustion control, relating to mixed and reformulated fuels with a lower boiling point fuel such as gasoline components or gas fuel and a higher boiling point fuel such as gas oil or heavy oil components to obtain the both advantages of their fuels for combustion. Here, vaporizing properties and the fuel transportation variables could be improved reasonably due to the formation of two-phase region. The vaporizing characteristics and combustion properties are examined for the mixed fuel of gasoline component and gas oil component, inside the constant volume vessel and RCEM.
Authors
Topic
Citation
Senda, J., Kawano, D., Hotta, I., Kawakami, K. et al., "Fuel Design Concept for Low Emission in Engine Systems," SAE Technical Paper 2000-01-1258, 2000, https://doi.org/10.4271/2000-01-1258.Also In
References
- Suzuki, H. Koike, N. Ishii, H. Odaka, M. “Exhaust Purification of Diesel Engines by Homogeneous Charge with Compression Ignition Part 1: Experimental Investigation of Combustion and Exhaust Emission Behavior Under Pre-Mixed Homogeneous Charge Compression Ignition Method” SAE Paper 970313 1997
- Suzuki, H. Koike, N. Ishii, H. Odaka, M. “Exhaust Purification of Diesel Engines by Homogeneous Charge with Compression Ignition Part 2: Analysis of Combustion Phenomena and NOX Formation by Numerical Simulation with Experiment” SAE Paper 970315 1997
- Takeda, Y. Nakagome, K. Niimura, K. “Emission Characteristics of Premixed Lean Diesel Combustion with Extremely Early Staged Fuel Injection” SAE Paper 961163 1996
- Harada, A. Shimazaki, N. Sasaki, S. Miyamoto, T. Akagawa, H. Tsujimura, K. “The Effects of Mixture Formation on Premixed Lean Diesel Combustion” SAE Paper 980533 1998
- Yanagihara, H. Sato, Y. Mizuta, J. “A Simultaneous Reduction of NOX and Soot in Diesel Engines under a New Combustion System (Uniform Bulky Combustion System - UNIBUS)” 17th International Vienna Motor Symposium Vienna 303 314 1996
- Hashizume, T. Akagawa, H. Tsujimura, K. “Emission Reduction Using Multiple Stage Diesel Combustion” Proc. the 14th Internal Combustion Engine Symposium Japan, (Nagoya) 259 264 1997
- Yokota, H. Kudo, Y. Nakajima, H. Kakegawa, T. Suzuki, T. “A New Concept for Low Emission Diesel Combustion” SAE Paper 970891 1997
- Kimura, S. Matsui, Y. Koike, M. “A Low Temperature Pre-mixed Combustion Concept for DI Diesel Engines” Nissan Technical Review 41 69 74 1997
- Furutani, M. Ohta, Y. Kono, M. Hasegawa, M. “An Ultra-Lean Premixed Compression-Ignition Engine Concept and its Characteristics” Proc. COMODIA 98 Kyoto 173 177 1998
- Tsurutani, K. Takei, Y. Fujimoto, Y. Matsudaira, J. Kumamoto, M. “The Effects of Fuel Properties and Oxygenates on Diesel Exhaust Emissions” SAE Paper 952349 1995
- Bertoli, C. Giacomo, N. D. Beatrice, C. “Diesel Combustion Improvements by the Use of Oxygenated Synthetic Fuels” SAE Paper 972972 1997
- Miyamoto, N. Ogawa, H. Nurun, N. M. Obata, K. Arima, T. “Smokeless, Low NOX, High Thermal Efficiency, and Low Noise Diesel Combustion with Oxygenated Agents as Main Fuel” SAE Paper 980506 1998
- Fleisch, T. McCarthy, C. Basu, A. Udovich, C. Charbonneau, P. Slodowske, W. Mikkelsen, S. E. McCandless, J. “A New Clean Diesel Technology : Demonstration of ULEV Emissions on a Navistar Diesel Engine Fueled with Dimethyl Ether” SAE Paper 950061 1995
- Kapus, P. Ofner, H. “Development of Fuel Injection Equipment and Combustion System for DI Diesels Operated on Dimethyl Ether” SAE Paper 950062 1995
- Kajitani, S. Chen, Z. L. Konno, M. Rhee, K. T. “Engine Performance and Exhaust Characteristics of Direct-Injection Diesel Engine Operated with DME” SAE Paper 972973 1997
- Sorenson, S. C. Mikkelsen, S. E. “Performance and Emissions of a 0.273 Litter Direct Injection Diesel Engine Fueled with Neat Dimethyl Ether” SAE Paper 950064 1995
- Ofner, H. Gill, D. W. Krotscheck, C. “Dimethyl Ether as Fuel for CI Engines - A New Technology and its Environmental Potential” SAE Paper 981158 1998
- Sheng, H. Z. Chen, L. Wu, C. K. “The Droplet Group Micro-Explosions in W/O Diesel Fuel Emulsion Sprays” SAE Paper 950855 1995
- Kadota, T. Yamasaki, H. Segawa, D. Kawatsu, T. Tsue, M. “Instantaneous Two Dimensional Visualization of Soot Concentration Profiles in the Diesel Spray Flame” Proc. COMODIA 98 Kyoto 105 110 1998
- Fujimoto, H. Senda, J. Shibata, I. Matsui, K. “New Concept on Lower Exhaust Emission of Diesel Engine” SAE Paper 952062 1995
- Senda, J. Hashimoto, K. Ifuku, Y. Fujimoto, H. “CO2 Mixed Fuel Combustion System for Reduction of NO and Soot Emission of Diesel Engine” SAE Paper 970319 1997
- Senda, J. Shibata, I. Asai, T. Fujimoto, H. “Improvement of Spray Characteristics in N2 Gas and Liquefied CO2 Dissolved Diesel Fuel” Proc. the 7th International Conference on Liquid Atomization and Spray Systems Seoul I 141 148 1997
- Senda, J. Yokoyama, T. Ikeda, M. Fujimoto, H. “Spray Combustion of Liquefied CO2 Mixed Fuel for NO and Soot Simultaneous Reduction” Proc. COMODIA 98 Kyoto 117 122 1998
- Senda, J. Ikeda, M. Yamamoto, M. Kawaguchi, B Fujimoto, H. “Low Emission Diesel Combustion System by Use of Reformulated Fuel with Liquefied CO2 and n-Tridecane” SAE Paper, 1999-01-1136 1999
- Senda, J. Yamaguchi, M. Wakashiro, T. Tsukamoto, T. Hojyo, K. Fujimoto, H. “Spray Characteristics of Pintle Type Injector under Low-Pressure Field” Proc. the 5th International Conference on Liquid Atomization and Spray Systems Gaithersburg 857 864 1991
- Senda, J. Nishikiori, T. Tsukamoto, T. Fujimoto, H. “Atomization of Spray under Low-Pressure Field from Pintle Type Gasoline Injector” SAE Paper 920382 1992
- Senda, J. Hojyo, Y. Fujimoto, H. “Modeling of Atomization Process in Flash Boiling Spray” SAE Paper 941925 1994
- Senda, J. Yamaguchi, M. Tsukamoto, T. Fujimoto, H. “Characteristics of Spray Injection form Gasoline Injector” JSME International Journal 37 4 931 936 1994
- Adachi, M. McDonell, V. G. Tanaka, D. Senda, J. Fujimoto, H. “Characterization of Fuel Vapor Concentration Inside a Flash Boiling Spray” SAE Paper 970871 1997
- Murrell, J. N. Bouchen, E. A. Nakanishi, K. et al. Properties of Liquids and Solutions Wiley Japan, Tokyo 150 155 1984
- Iida, N. Watanabe, J. “Surrounding Gas Condition Effects on NOX and Particulate” Proc. COMODIA 90 Kyoto 625 632 1990
- Iida, N. “Surrounding Gas Condition Effects on Soot Formation and Extinction - Observation of Diesel Spray Combustion Using a Rapid Compression Machine” SAE Paper 930603 1993
- Machacon, H. T. C. Shiga, S. Karasawa, T. Nakamura, H. “The Effect of EGR on Diesel Particulate Emissions” Proc. COMODIA 94 Yokohama 287 292 1994
- Gaydon, A. G. Wolfhard, H. G. Flames - Their structure, radiation and temperature Chapman and Hall London 193 195 1953