This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Transition from Combustion to Variable Compression Braking
Technical Paper
2000-01-1228
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2000 World Congress
Language:
English
Abstract
Commercial Heavy vehicles (CHVs) are an efficient and reliable link between marine, railroad, and air transportation nodes. The vehicle braking power imposes an important constraint in the allowable vehicle speed. The compression brake augments the vehicle retarding power and is currently typically used as an on-off device by experienced drivers. Hardware and software advances allow modulation of the compression brake power through variable valve timing, and thus, enable integration of the compression brake with service brakes. To analyze how much the compression brake affects vehicle speed during braking, we develop a crank angle engine model that describes the intrinsic transient interactions between individual cylinder intake and exhaust gas process, turbocharger dynamics, and vehicle dynamics during combustion and variable brake valve timing. The model is validated using experimental data. Using system identification techniques we develop low-order mean-value models appropriate for control analysis and design.
Recommended Content
Authors
Citation
Moklegaard, L., Stefanopoulou, A., and Schmidt, J., "Transition from Combustion to Variable Compression Braking," SAE Technical Paper 2000-01-1228, 2000, https://doi.org/10.4271/2000-01-1228.Also In
References
- Borman G. L. Ragland K. W. Combustion Engineering McGraw-Hill 1998
- Cummins D. D. “The Jacobs Engine Brake Application and Performance,” SAE Paper No. 660740
- Fitch J. W. Motor Truck Engineering Handbook SAE Inc. 1994
- Gerdes C. J. Brown S. A. Hedrick K. J. “Brake System Modeling for Vehicle Control,” Advanced Automotive Technologies - 1995 ASME IMECE 105 112 1995
- Heywood J. B. Internal Combustion Engine Fundamentals McGraw-Hill 1988
- Hu H. Israel M. A. Vorih J. M. “Variable Valve Actuation and Diesel Engine Retarding Performance,” SAE Paper No. 970342
- Israel M. A. Hu H. “Impact of Ambient Parameter on Operating Efficiency of Compression Release Engine Retarder Systems on Heavy Duty Diesel Engines,” SAE Paper No. 932972
- Meistrick Z. “Jacobs New Engine Brake Technology,” SAE Paper No. 922448
- Moklegaard L. Stefanopoulou A. Schmidt J. “Braking Control for Heavy Duty-vehicles,” NSF Workshop on the Integration of Modeling and Control for Automotive Systems Santa Barbara 1999
- Moklegaard L. Stefanopoulou A. “Compression Braking Control for Heavy-Duty Commercial Vehicles,” 2000 American Control Conference
- Novak J. M. “Simulation of the Breathing Process and Air-Fuel Ratio Distribution Characteristics of Three-Valve, Stratified Charge Engines,” SAE Paper No. 770881 1977
- Raza H. Xu Z. Yang B. “Brake Modeling for AVCS Application,” 1994
- Shigley J. E. Uicker J. J. Theory of Machines and Mechanisms 2nd McGraw-Hill 1995
- Yanakiev D. Kanelakopoulos I. “Longitudinal Control of Automated CHV's with Significant Actuator Delays,” Proc. 36th Confer, on Decision and Control San Diego 1997