This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
On Drawbeads in Sheet Metal Forming
Technical Paper
2000-01-1107
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2000 World Congress
Language:
English
Abstract
This paper examines a history of numerical methods for evaluating drawbeads in sheet metal forming, from early work with Dr. Sing Tang at the Ford Scientific Research Laboratory on special purpose drawbead simulation software, to modern general purpose software simulations incorporating analytic drawbeads in full 3D sheet forming analyses. Future directions in the field are explored through an example utilizing nonlinear optimization for drawbead design.
Topic
Citation
Maker, B., "On Drawbeads in Sheet Metal Forming," SAE Technical Paper 2000-01-1107, 2000, https://doi.org/10.4271/2000-01-1107.Also In
References
- Triantafyllidis, N. Maker, B.N. Samanta, S.K. An Analysis of Drawbeads in Sheet Metal Forming, Part I – Problem Formulation ASME J. of Eng. Mat. Tech., 108 321 327 1986
- Triantafyllidis, N. Maker, B.N. Samanta, S.K. Grab, G. An Analysis of Drawbeads in Sheet Metal Forming, Part II – Experimental Verification ASME J. of Eng. Mat. Tech., 109 164 170 1987
- LS-DYNA Version 950 Livermore Software Technology Corporation May 1999
- LS-OPT Version 1 Livermore Software Technology Corporation September 1999
- Roux, W.J Stander, N. Haftka, R.T Response Surface Approximations for Structural Optimization IJNME 42 517 534 1998
- Chu, E. Li, M. The Onset and Growth of Elastoplastic Wrinkling of Aluminum Alloy Sheets Proceedings of NUMISHEET ’96 Lee, Kinzel Wagoner, 228 233 1996