This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Numerical Modeling Technique for Tailor Welded Blanks
Technical Paper
2000-01-0410
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2000 World Congress
Language:
English
Abstract
The forming behaviors of tailor-welded blanks (TWBs) have been widely studied since they were first developed as a way of using collectible offal. A typical TWB is composed of several base metals, which might have different mechanical properties as well as thickness. Moreover, a TWB contains heat-affected zone (HAZ) which has quite different mechanical properties as base materials do. Little published information on HAZ is available up to now, especially its numerical modeling. It is not clear how much HAZ affects the formability and the springback of TWB. In this paper, the mechanical properties of HAZ are determined from hardness test and tensile test. The eccentric load applied in tensile test is essential for decomposing the properties of the base materials and the HAZ. Various finite element modes for TWB are presented. An appropriate model based on the considerations of accuracy and computing efficiency is suggested. Free bend test (three-point bend test) and stretch bend test (OSU formability test) are performed to verify the proposed numerical modeling technique for TWBs.
Recommended Content
| Technical Paper | Describing the Formability of Tailor Welded Blanks |
| Technical Paper | New Apparatus and Method for Forming Tailor Welded Blanks |
| Technical Paper | Tailor Welded Blank Technology for Automotive Applications |
Authors
Citation
Zhao, K., Chun, B., and Lee, J., "Numerical Modeling Technique for Tailor Welded Blanks," SAE Technical Paper 2000-01-0410, 2000, https://doi.org/10.4271/2000-01-0410.Also In
References
- Radlmayr, K.M. Szinyur, J. IDDRG Working Groups Meeting Associazione Italiana Di Metallurgia, I- 20121 MILANO, Piazzale Rodolfo Morandi, 2 Italy
- Saunders, F.I. Wongoner, R.H. Forming of Tailor-Welded Blanks, Ph.D. dissertation 1995
- Mustafa, A.A., Brouwers, D., Shulkin, L., et al., “Deep Drawing of Round Cups from Tailor-Welded Blanks”, Journal of Materials Processing Technology 53, 1995, 684 694.
- “Tailor Welded Blank Design and Manufacturing Manual”, A/S P Technical Report, Auto/Steel Partnership, Southfield, MI, 1995.
- ASTM Standard E-8, American Standard of Testing of Materials
- Mehta, Manish “The Status of the Springback Predictability ATP Project”, 3 rd International Conference on Sheet Metal Forming Technology, Oct. 5-7, 1998, Columbus, OH, USA
- Bart Carleer, Finite Element Analysis of Deep Drawing, Ph.D. Thesis, March 1997 University of Twente, The Netherlands
- Kunmin Zhao, Cyclic Stress-Strain Curve and Springback Simulation, Ph.D. Dissertation, September 1999 The Ohio State University, Columbus, OH, USA
- Zhao K.M. Lee, J.K. “On Simulation of Bending/Reverse Bending of Sheet Metals” Proceedings of International Mechanical Engineering Congress & Exposition, Nov 14-19 1999 Nashville, Tennessee, USA