This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Comparison Between Direct and Indirect Fuel Injection in an S.I. Two-Stroke Engine
Technical Paper
1999-01-3311
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Gasoline direct injection in two-stroke engines has led to even more advantageous results, in comparison with four-stroke engines, as far as unburned hydrocarbon emissions and fuel consumption are concerned. A new electronically controlled injection system has therefore been fitted in a crankcase-scavenged two-stroke engine, previously set up with indirect injection equipment. The comparison between the performance of the two gasoline feeding systems has highlighted the potential of the direct injection strategy. The direct injection system here tested has allowed the optimization of the engine torque characteristic at wide open throttle operating conditions. Moreover, the engine original exhaust system, has been replaced with an expansion-chamber exhaust-pipe system, in order to evaluate the impact of direct gasoline injection also with these optimized exhaust configuration.
Recommended Content
Authors
Topic
Citation
Badami, M., Marzano, M., Millo, F., and Nuccio, P., "Comparison Between Direct and Indirect Fuel Injection in an S.I. Two-Stroke Engine," SAE Technical Paper 1999-01-3311, 1999, https://doi.org/10.4271/1999-01-3311.Also In
References
- Katsuo et al. “Combustion Control Technologies of Mitsubishi Direct S.I. Engine” International SAE Congress Detroit 26-29 February 1996 Paper N. 960600
- Takagi Y. et al. “Simultaneous Attainment of Low Fuel Consumption, High Output Power and Low Exhaust Emissions in Direct Injection SI Engines” SAE Paper N. 980149
- Noma et al. “Gasoline Direct Injection Engine for the European Market” SAE Paper N. 980150
- Houston R. Cathcart G. “Combustion and Emission Characteristics of Orbital's Combustion Process Applied to Multi-Cylinder Automotive Direct Injected 4-Stroke Engines” SAE Paper N. 980153
- Kano M. et al. “Analysis of Mixture Formation of Direct Injection Gasoline Engine” SAE Paper N. 980157
- Kuwahara K. et al. “Control Strategy for Engine Performance Improvement in a Gasoline Direct Injection Engine” SAE Paper N. 980158
- Wirth M. et al. “Gasoline DI Engines: The Complete System Approach by Interaction of Advanced Development Tools” SAE Paper N. 980492
- Xu M. Markle L.E. “CFD-Aided Development of Spray for an Outwardly Opening Direct Injection Gasoline Injector” SAE Paper No. 980493
- Preussner C. “GDI: Interaction Between Mixture Preparation, Combustion System and Injector Performance” SAE Paper No. 980498
- Yang X. et al. “Diaphragm Injection Carburettor (DIC) for Stratified-Scavenging of Small Two-Stroke Gasoline Engine” SAE Paper N. 960364
- Abata D. Wellenkotter K. “Characterization of Ignition and Parametric Study of a Two-Stroke-Cycle Direct-Injected Gasoline Engine” SAE Paper N. 920423
- Rochelle P. “Emission and Fuel Consumption Reduction in a Two-Stroke Engine Using Delay-Charging” SAE Paper N. 951784
- Bell G. Finucci C. “Exhaust Emission Sensitivities with Direct Injection on a 50 cc Scooter” SAE Paper N. 970365
- Kenny R.G. Kee R.J. Carson C.E. Blair G.P. “Application of Direct Air-Assisted Fuel Injection to an S.I. Cross-Scavenged Two-Stroke Engine” SAE Paper N. 932396
- Murayama T. et al. “Study on Exhaust Control Valves and Direct Air-Fuel Injection for Improving Scavenging Process in two-Stroke Gasoline Engines” SAE Paper N. 960367
- Marini A. Gentili R. “Sistema PRO-JECT di Iniezione Pneumatica per Motori a Due Tempi ad A.C.” Congresso Nazionale ATI 1995 St.Vincent
- Miyamoto T. et al. “Structure of Spray from an Air-Assist Hollow-Cone Injector” SAE Paper N. 960771
- Wiartalla A. et al. “Influence of Injection System Parameters on Spray Development Combustion and Soot Formation by Optical Measurement Techniques in a Model Combustion Chamber” SAE Paper. 950233
- Kabayashi K. et al. “Effect of Fuel Atomization on the Lean-Burn Characteristics Under Steady Condition in a Spark-Ignition Engine” SAE Paper N. 960460
- Bartolini C.M. Chiatti G. Vincenzi G. “Performance Analysis of a Two-Stroke Gasoline Engine with Direct-Injection” SAE Paper N. 931508
- Blair G.P. “Design and Simulation of Two-Stroke Engines” SAE inc. 1996
- Douglas R. “AFR and Emissions Calculations for Two-Stroke Cycle Engines” SAE Paper N. 901599
- Kuhnt V.H.W. Burger W. Knapp G. “Zweitakt-Kleinmotoren mit Direkteinspritzung” MTZ Motortechnische Zeitschrift 57 1996 1