This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
High-efficient Machining of Aerospace-alloys
Technical Paper
1999-01-2293
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In many manufacturing tasks the shortening of production times can only be achieved by optimizing the whole manufacturing sequence. Nevertheless main production times can be reduced significantly by single optimizations during particular cutting processes, when the production time determined by the parameters cutting speed and feed rate, is raised in the field of high-efficient machining. The practicability of this strategy depends on the material to cut. In this paper the potentials of a matched tool geometry with regard to the reachable material removal rate and the achievable component quality are presented. The shown research contains the mostly employed manufacturing processes in aircraft component manufacturing like drilling, reaming, milling as well as new machining strategies like circular milling of aerospace alloys.
Recommended Content
Technical Paper | Affordable Reconfigurable Tooling |
Technical Paper | Electron Beam Weldments for Large Complex Shapes |
Technical Paper | Process Speeds for Drilling and Reaming CFRP and CFRP/Metallic Stacks |
Authors
Topic
Citation
Tönshoff, H., Andrae, P., and Lapp, C., "High-efficient Machining of Aerospace-alloys," SAE Technical Paper 1999-01-2293, 1999, https://doi.org/10.4271/1999-01-2293.Also In
References
- Salomon, C. Verfahren zur Bearbeitung von Metallen oder bei einer Bearbeitung durch schneidende Werkzeuge sich ähnlich verhaltender Werkstoffe. Deutsches Reichspatent 523 594 27 November 1925
- Koontz, J. L. Ultra-high-speed machining American Machines Juni 1977 135 139
- Schulz, H. Arnold W. Schere J. Hochgeschwindigkeits-Zerspanung: neue Technologie oder Schlagwort? Werkstatt und Betrieb 114 1981 527 531
- Schulz, H. Moriwaki, T High speed machining Annals of the CIRP 41 1992 637 645
- Jaissle, C. HSC-Maschinentechnik in hochproduktiven Anlagen. 9 Darmstädter Fertigungstechnisches Kolloquium Darmstadt 1996 1 12
- Tönshoff, H.K. Blawit: C. High-Speed-Cutting of Grey Cast Iron Fourth International Symposium on Magnetic Bearings 23-26.08.94 Zürich 525 530
- Week, M. Schubert I. Steilkegel-Alternative. NC-Fertigung 1 1993 22 24
- Week, M. Schumacher A. Derzeitiger Stand der Hochgeschwindigkeitsbearbeitung - ein Überblick wt Werkstattstechnik 87 1997 409 414
- Weinert, K. Zukunftsperspektiven in der spanenden Fertigung http://www-isf.maschinenbau.unidortmund.de/tagung97/tagung/weiner.htm
- Heisel, U. Feinauer, A. Scheurer F. Hochgeschwin-digkeitsfräsen: Eine Alternative zum Feinbohren? Dima 10 95 1995 35 40