This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Evaluation Method for Vibratory Forces Caused by Propeller Shaft
Technical Paper
1999-01-1763
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper describes a bench test evaluation method for vibratory forces caused by a propeller shaft. Most of the vibratory forces are usually generated at the joints of a propeller shaft. They are classified as vibratory forces of axial, radial and moment directions. Axial force can be easily evaluated by measuring the load washer outputs. On the contrary, radial and moment forces can not be analyzed enough clearly even though the outputs are measured, because the load washer for both forces is the same and the outputs depend on the sum of these forces. In this paper, an algorithm for the evaluation method is described. In this method the outputs, as a sum of the forces, are by computation translated separately into kinds of forces which are generated at each joint. The translated results are calculated using an inverse matrix of influence coefficients between the forces and the outputs. Using this method, the evaluation is effective for analyzing the mechanism of the forces.
Recommended Content
Authors
Citation
Ono, K., "Evaluation Method for Vibratory Forces Caused by Propeller Shaft," SAE Technical Paper 1999-01-1763, 1999, https://doi.org/10.4271/1999-01-1763.Also In
References
- Ono, K. Yagi, K. Shida, T. “Analysis of The Moment Caused Friction of Cardan Joint” Trans. of JSAE 46 1990
- Saigo, M. Okada, Y. Ono, K. “Self-Excited Vibration Caused by Internal Friction in Universal Joint and Its stabilizing Method” Trans. ASME, Journal of Vibration and Acoustics 119 1997
- Yagi, K. Ono, K. “The Development of Bench Tester To Evaluate Propeller Shaft” Atsugi Technical Review 2 1988
- Wagner E. R. “Cardan or Hooke Universal Joint” Universal Joint and Drive shaft Design Manual, Section 3.1.1., SAE, AE-7