This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Strength of Bonded Shrink-Fitted Joints Subjected to Push-Off Forces
Technical Paper
1999-01-1030
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Shrink fit has been used commonly for joining the cylindrical components such as shaft and gears. It is noted recently the shrink fitted joint with anaerobic adhesives is adopted in order to improve it's joint strength. In a reliable design of bonded shrink fitted joints, it is necessary to know the contact stress distributions at the interfaces. In this paper, the interface stress distribution of bonded shrink fitted joint under push-off force is analyzed by using axisymmetric theory of elasticity as four-body contact problem. Analogical test is conducted to determine the relationship between the normal stress and the shear stress. Using the interface stress distribution and analogical test results, a method for estimating the joint strength is proposed. In the numerical calculations, the effect of the outer diameter and Young's modulus of the rings and the engagement length on the contact stress distributions at the interfaces are clarified. Push-off force measurement was carried out for bonded shrink fitted joints. In the experiments, the effect of shrink fit interference and the outer diameters of ring on the joint strength are examined. The numerical results are in a fairly good agreement with the experimental results. It is found that the strength of the bonded shrink fitted joint is greater than that of shrink fitted joint.
Recommended Content
Authors
Citation
Yoneno, M., Sawa, T., and Shimotakahara, K., "Strength of Bonded Shrink-Fitted Joints Subjected to Push-Off Forces," SAE Technical Paper 1999-01-1030, 1999, https://doi.org/10.4271/1999-01-1030.Also In
References
- Conway, H.d. Famham, K.A. Contact Stresses between Cylindrical Shafts and Sleeves Int. J .Engng.Sci., 5, 541 554 1967
- Conway, H.d. Famham, K.A. The Shrink Fit of Flexible Sleeve on a Shaft Int.J.Mech.Sci., 10, 757 764 1968
- Oda, J. Shibahara, M. Miyamoto, H. On Shrink-Fit Stresses between an Infinite Cylinder and a Finite Hollow Cylinder and’, Bull.JSME, 15, 88 1147 1155 1972
- Megahed, M.M. Abdel-Kader, M.S. Elastplastic Analysis of Rotating Shrink-Fitted Discs with Nonlinear Hardening Characteristics Int.J.Solids Structures, 30 6 751 765 1993
- Orcan, Y. Gamer, U. The Shrink Fit Consisting of Elastic Hollow Shaft and Nonlinearly Hardening Elastic-Plastic Hub Acta Mech. 81 97 108 1990
- Neda, N. Transient Thermoelastic Contact Stress in a Short-Length Circular Cylinder J.Thermal.Stresses 8 413 424 1985
- Kato, K. Kayaba, T. Nitta, I. Shimoda, S. The Effect of Surface Roughness on Fitting Strength of Shrink Fit between Ceramic and Elements Trans.ASME 111 318 325 JULY 1989
- Shibahara, M. Oda, J. Problems on the Finite Hollow Cylinders under the Axially Symmetrical Deformations Bull.JSME 11 48 1000 1014 1968