This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Characteristics of Mixture Formation in a Direct Injection SI Engine with Optimized In-Cylinder Swirl Air Motion
ISSN: 0148-7191, e-ISSN: 2688-3627
Published March 01, 1999 by SAE International in United States
Annotation ability available
This paper presents a study of mixture formation in the combustion chamber of a direct-injection SI engine. In-cylinder flow measurement was conducted using laser Doppler velocimetry (LDV) and particle image velocimetry (PIV), and visualization of fuel vapor behavior was done using laser-induced fluorescence (LIF). Further, fast response flame ionization detector (FID) was used to measure the hydrocarbon (HC) concentrations in the vicinity of the spark plug. Thereby mixture concentrations in the vicinity of the spark plug, within the mixture distribution observed using LIF, were quantified. Results revealed that an upward flow forms near the center of the cylinder in the latter half of the compression stroke and goes from the piston crown toward the cylinder head. This upward flow is caused by the synergistic effect of the swirl motion generated in the cylinder and the cylindrical bowl provided in the piston crown eccentrically to the central axis of the cylinder. It was confirmed that the fuel was initially trapped and vaporized in the piston bowl, then transported as a vapor cloud by the upward flow to the spark plug, thereby forming charge stratification. Performance experiments were conducted to study the ranges of fuel injection and ignition timing necessary for achieving stable stratified charge combustion. Comparisons of the data obtained with LIF visualization results and FID measurements revealed the conditions most desirable for achieving stable stratified charge combustion.
CitationKakuhou, A., Urushihara, T., Itoh, T., and Takagi, Y., "Characteristics of Mixture Formation in a Direct Injection SI Engine with Optimized In-Cylinder Swirl Air Motion," SAE Technical Paper 1999-01-0505, 1999, https://doi.org/10.4271/1999-01-0505.
- Iwamoto Y., Noma K., Yamaguchi T., Ando H., “Development of Gasoline Direct Injection Engine”, SAE Paper 970541
- Harada J., Tomita T., et al,. “Development of Direct Injection Gasoline Engine”, SAE Paper 970540
- Itoh T., Iiyama A., Muranaka S., Takagi Y., “Combustion characteristics of a direct-injection stratified charge S.I engine”, Japan Society of Automotive Engineers (JSAE) Trans. Vol. 19, No. 3, July 1998
- Urushihara T., Murayama T., et al., “Turbulence and Cycle-by-Cycle Variation of Mean Velocity Generated by Swirl and Tumble Flow and Their Effects on Combustion”, SAE Paper 950813
- Li K., Urushihara T., et al., 10th Joint Symposium on Combustion Engines, Proceedings, p. 85, 1992
- Urushihara T., Nakada T., et al., Japan Society of Automotive Engineers (JSAE), Trans. Vol. 27, No. 2, April 1996
- Cambustion Ltd., HFR400 Fast FID User's Manual
- Summers T., Collings N., “Modelling the Transit Time of a Fast Response Flame Ionization Detector During In-Cylinder Sampling”, SAE Paper 950160