This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Investigation of Different Factors Influencing the Springback, Surface Roughness, and Thinning for Polyvinyl Chloride during Single Point Incremental Forming

Journal Article
05-13-03-0023
ISSN: 1946-3979, e-ISSN: 1946-3987
Published July 29, 2020 by SAE International in United States
Investigation of Different Factors Influencing the Springback, Surface Roughness, and Thinning for Polyvinyl Chloride during Single Point Incremental Forming
Sector:
Citation: Patel, S., Kagzi, S., and Jain, P., "Investigation of Different Factors Influencing the Springback, Surface Roughness, and Thinning for Polyvinyl Chloride during Single Point Incremental Forming," SAE Int. J. Mater. Manf. 13(3):2020, https://doi.org/10.4271/05-13-03-0023.
Language: English

Abstract:

Single point incremental forming (SPIF) is a sheet forming technology giving low volume production with high flexibility characteristics. The flexibility of the process is mainly related to the fact that incremental forming does not require a dedicated die to operate as compared to other forming processes. Polymers are extensively used for many applications because of their good mechanical properties. Considerable research has been reported for the SPIF of metals, but the researches on polymers are in scarce. In the present work, SPIF is performed on one of the polymers known as polyvinyl chloride. The effect of wall angle, feed rate, and step size on springback, thinning, and surface roughness is observed. It was found that the springback mainly depends on the wall angle but it is least dependent on the feed rate. The thinning and the surface roughness also mainly depend on the wall angle but are least dependent on step size.