This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Soot Observations and Exhaust Soot Comparisons from Ethanol-Blended and Methanol-Blended Gasoline Combustion in a Direct-Injected Engine

Journal Article
04-11-02-0008
ISSN: 1946-3952, e-ISSN: 1946-3960
Published May 07, 2018 by SAE International in United States
Soot Observations and Exhaust Soot Comparisons from Ethanol-Blended and Methanol-Blended Gasoline Combustion in a Direct-Injected Engine
Sector:
Citation: Vedula, R., Men, Y., Atis, C., Stuecken, T. et al., "Soot Observations and Exhaust Soot Comparisons from Ethanol-Blended and Methanol-Blended Gasoline Combustion in a Direct-Injected Engine," SAE Int. J. Fuels Lubr. 11(2):163-180, 2018, https://doi.org/10.4271/04-11-02-0008.
Language: English

References

  1. Zhao, F., Lai, M.C., and Harrington, D.L., “Automotive Spark-Ignited Direct-Injection Gasoline Engines,” Progress in Energy and Combustion Science 25:437-562, 1999.
  2. Alkidas, A.C., “Combustion Advancements in Gasoline Engines,” Energy Conversion and Management 48(11):2751-2761, 2007.
  3. Li, T., Gao, Y., Wang, J., and Chen, Z., “The Miller Cycle Effects on Improvement of Fuel Economy in a Highly Boosted, High Compression Ratio, Direct-Injection Gasoline Engine: EIVC vs. LIVC,” Energy Conversion and Management 79:59-65, 2014.
  4. Zhang, S. and McMahon, W., “Particulate Emissions for LEV II Light-Duty Gasoline Direct Injection Vehicles,” SAE Int. J. Fuels Lubr. 5(2):637-646, 2012, doi:10.4271/2012-01-0442.
  5. Saliba, G., Saleh, R., Zhao, Y., Presto, A.A. et al., “Comparison of Gasoline Direct-Injection (GDI) and Port Fuel Injection (PFI) Vehicle Emissions: Emission Certification Standards, Cold-Start, Secondary Organic Aerosol Formation Potential, and Potential Climate Impacts,” Environmental Science & Technology 51:6542-6552, 2017.
  6. Zelenyuk, A., Wilson, J., Imre, D., Stewart, M. et al., “Detailed Characterization of Particulate Matter Emitted by Lean-Burn Gasoline Direct Injection Engine,” International Journal of Engine Research 18:560-572, 2017.
  7. Lee, K., Seong, H., Sakai, S., Hageman, M. et al., “Detailed Morphological Properties of Nanoparticles from Gasoline Direct Injection Engine Combustion of Ethanol Blends,” SAE Technical Paper 2013-24-0185, 2013, doi:10.4271/2013-24-0185.
  8. Piock, W., Hoffmann, G., Berndorfer, A., Salemi, P. et al., “Strategies towards Meeting Future Particulate Matter Emission Requirements in Homogeneous Gasoline Direct Injection Engines,” SAE Int. J. Engines 4(1):1455-1468, 2011, doi:10.4271/2011-01-1212.
  9. Park, C., Kim, S., Kim, H., Lee, S. et al., “Effect of a Split-Injection Strategy on the Performance of Stratified Lean Combustion for a Gasoline Direct-Injection Engine,” Journal of Automobile Engineering 225:1415-1426, 2011.
  10. Costa, M., Sorge, U., Merola, S., Irimescu, A. et al., “Split Injection in a Homogeneous Stratified Gasoline Direct Injection Engine for High Combustion Efficiency and Low Pollutants Emission,” Energy 117:405-415, 2016.
  11. Kim, T.Y., Park, C., Oh, S., and Cho, G., “The Effects of Stratified Lean Combustion and Exhaust Gas Recirculation on Combustion and Emission Characteristics of an LPG Direct Injection Engine,” Energy 115:386-396, 2016.
  12. Turner, D., Xu, H., Cracknell, R.F., Natarajan, V. et al., “Combustion Performance of Bio-Ethanol at Various Blend Ratios in a Gasoline Direct Injection Engine,” Fuel 90:1999-2006, 2011.
  13. Lee, K., Seong, H., Sakai, S., Hageman, M. et al., “Detailed Morphological Properties of Nanoparticles from Gasoline Direct Injection Engine Combustion of Ethanol Blends,” SAE Technical Paper 2013-24-0185, 2013, doi:10.4271/2013-24-0185.
  14. Luo, Y., Zhu, L., Fang, J., Zhuang, Z. et al., “Size Distribution, Chemical Composition and Oxidation Reactivity of Particulate Matter from Gasoline Direct Injection (GDI) Engine Fueled with Ethanol-Gasoline Fuel,” Applied Thermal Engineering 89:647-655, 2015.
  15. Karavalakis, G., Short, D., Vu, D., Russell, R.L. et al., “The Impact of Ethanol and Iso-Butanol Blends on Gaseous and Particulate Emissions from Two Passenger Cars Equipped with Spray-Guided and Wall-Guided Direct Injection SI (Spark Ignition) Engines,” Energy 82:168-179, 2015.
  16. Fourier, S., Simon, G., and Seers, P., “Evaluation of Low Concentrations of Ethanol, Butanol, BE, and ABE Blended with Gasoline in a Direct-Injection, Spark-Ignition Engine,” Fuel 181:396-407, 2016.
  17. Sementa, P., Vaglieco, B.M., and Catapano, F., “Thermodynamic and Optical Characterizations of a High Performance GDI Engine Operating in Homogeneous and Stratified Charge Mixture Conditions Fueled with Gasoline and Bio-Ethanol,” Fuel 96:204-219, 2012.
  18. Gong, J. and Rutland, C.J., “Filtration Characteristics of Fuel Neutral Particulates Using a Heterogeneous Multiscale Filtration Model,” Journal of Engineering for Gas Turbines and Power 137:111507, 2015.
  19. Chen, L., Stone, R., and Richardson, D., “A Study of Mixture Preparation and PM Emissions Using a Direct Injection Engine Fuelled with Stoichiometric Gasoline/Ethanol Blends,” Fuel 96:120-130, 2012.
  20. Khalek, I., Bougher, T., and Jetter, J., “Particle Emissions from a 2009 Gasoline Direct Injection Engine Using Different Commercially Available Fuels,” SAE Int. J. Fuels Lubr. 3(2):623-637, 2010, doi:10.4271/2010-01-2117.
  21. Wang, Y., Zheng, R., Qin, Y., Peng, J. et al., “The Impact of Fuel Compositions on the Particulate Emissions of Direct Injection Gasoline Engine,” Fuel 166:543-552, 2016.
  22. Liang, B., Ge, Y., Tan, J., Han, X. et al., “Comparison of PM Emissions from a Gasoline Direct Injected (GDI) Vehicle and a Port Fuel Injected (PFI) Vehicle Measured by Electrical Low Pressure Impactor (ELPI) with Two Fuels: Gasoline and M15 Methanol Gasoline,” Journal of Aerosol Science 57:22-31, 2013.
  23. Balki, M.K., Sayin, C., and Canacki, M., “The Effect of Different Alcohol Fuels on the Performance, Emission and Combustion Characteristics of a Gasoline Engine,” Fuel 115:901-906, 2014.
  24. Wang, X., Ge, Y., Liu, L., Peng, Z. et al., “Evaluation on Toxic Reduction and Fuel Economy of a Gasoline Direct Injection-(GDI-) Powered Passenger Car Fueled with Methanol-Gasoline Blends with Various Substitution Ratios,” Applied Energy 157:134-143, 2015.
  25. Vedula, R., Stuecken, T., Schock, H., Squibb, C. et al., “Optical Engine Operation to Attain Piston Temperatures Representative of Metal Engine Conditions,” SAE Int. J. Engines 10(3):767-777, 2017, doi:10.4271/2017-01-0619.
  26. Squibb, C., Schock, H., Vedula, R., and Stuecken, T., “Analysis of Variations in Fuel Spray, Combustion, and Soot Production in an Optical Diesel Engine Operating under High Simulated Exhaust Gas Recirculation Operating Conditions,” SAE Technical Paper 2016-01-0727, 2016, doi:10.4271/2016-01-0727.
  27. Drake, M.C., Fansler, T.D., and Lippert, A.M., “Stratified-Charge Combustion: Modeling and Imaging of a Spray-Guided Direct-Injection Spark-Ignition Engine,” Proceedings of the Combustion Institute 30:2683-2691, 2005.
  28. Whitaker, P., Kapus, P., Ogris, M., and Hollerer, P., “Measures to Reduce Particulate Emissions from Gasoline DI Engines,” SAE Int. J. Engines 4(1):1498-1512, 2011, doi:10.4271/2011-01-1219.
  29. Palmer, J., Ramesh, M., Kirsch, V., Reddemann, M. et al., “Spray Analysis of C8H18O Fuel Blends Using High-Speed Schlieren Imaging and Mie Scattering,” SAE Technical Paper 2015-24-2478, 2015, doi:10.4271/2015-24-2478.

Cited By