AS27197A SEAL, PLAIN, RUBBER (HOT AIR RESISTANT 400 °F) MOLD IN GROOVE
Revised
02/19/2008
- Features
- Issuing Committee
- Content
- No Scope available
- Content
- WHEN MS27197 WAS CONVERTED TO AS27197 THE PLATE MATERIAL WAS UPDATED FROM MIL-S-5059 302 ANNEALED TO AMS 5515. MIL-S-5059 CANCELLATION NOTICE 1 STATES THAT 302 ANNEALED WAS REPLACED BY AMS 5516. THIS REVISION CORRECTS THAT ERROR.
-
MATERIAL: METAL RETAINER, CORROSION RESISTANT STEEL, SPEC AMS 5516 RUBBER SEAL, RUBBER PER SPEC ZZ-R-765, CLASS 2B, GRADE 70. -
REMOVE ALL BURRS AND SHARP EDGES.
-
DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: DECIMALS ±.005; FRACTIONS ±1/64; ANGLES ±1/2°.
-
INDIVIDUALLY PACKAGE PER SPEC MIL-STD-2073-1, METHOD 33.
-
PRODUCT SHALL BE PERMANENTLY IDENTIFIED AS TO MANUFACTURER AND TYPE.
-
SEAL DESIGN MUST PROVIDE SUBSTANTIAL FILLING OF THE GROOVE WHEN ASSEMBLED.
-
FOR DESIGN FEATURE PURPOSES, THIS STANDARD TAKES PRECEDENCE OVER PROCUREMENT DOCUMENTS REFERENCED HEREIN.
-
REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON THE DATE OF INVITATIONS FOR BID.
-
A CHANGE BAR ( | ) LOCATED IN THE LEFT MARGIN IS FOR THE CONVENIENCE OF THE USER IN LOCATING AREAS WHERE TECHNICAL REVISIONS, NOT EDITORIAL CHANGES, HAVE BEEN MADE TO THE PREVIOUS ISSUE OF THIS DOCUMENT. AN (R) SYMBOL TO THE LEFT OF THE DOCUMENT TITLE INDICATES A COMPLETE REVISION OF THE DOCUMENT, INCLUDING TECHNICAL REVISIONS. CHANGE BARS AND (R) ARE NOT USED IN ORIGINAL PUBLICATIONS, NOR IN DOCUMENTS THAT CONTAIN EDITORIAL CHANGES ONLY.
-
- Pages
- 2
- Citation
- SAE International Technical Standard, SEAL, PLAIN, RUBBER (HOT AIR RESISTANT 400 °F) MOLD IN GROOVE, SAE Standard AS27197A, Revised February 2008, Issued March 2001, https://doi.org/10.4271/AS27197A.