This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
70 MPa Compressed Hydrogen Surface Vehicle Fueling Connection Device and Optional Vehicle to Station Communications
- Ground Vehicle Standard
- J2799_200705
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This technical information report specifies a guideline for the hardware requirements for fueling a Hydrogen Surface Vehicle (HSV) with compressed hydrogen storage rated at a Nominal Working Pressure of 70 MPa. It contains a description of the receptacle geometry and optional communication hardware and communications protocol to refuel the HSV. The intent of this document is to enable harmonized development and implementation of the hydrogen fueling interfaces.
It is intended to be utilized for hydrogen vehicle field evaluations until enough information is collected to enable standardization. The receptacle portion of this document is to be reevaluated utilizing international field data in approximately two (2) years and subsequently superseded by SAE J2600 in the 2009 timeframe. At that time, input would be gathered from international locations through representation in the SAE Fuel Cell Standards Committee in order to arrive at a final decision regarding the direction of the receptacle and communications standard.
The communications portion of this document is also to be reevaluated utilizing international field data and subsequently superseded by SAE J2601. It is anticipated that the communications protocol and hardware could be standardized before the above mentioned timeframe.
It is not the intent of this document to imply a position regarding the commercial fueling protocol, communication, or non-communication strategy, but simply serves as a reference for the receptacle hardware and IRDA communications if this strategy is selected. In addition, it is not intended be referenced by other Standard and/or Code organizations.
Rationale
Not applicable.
Recommended Content
Data Sets - Support Documents
No Datasets Available
Issuing Committee
The Fuel Cell Standards Committee is responsible for establishing standards for hydrogen and fuel cell vehicles. Standards will cover the safety aspects of hydrogen, fuel cell, and electrical systems in the vehicle, test procedures to establish the performance of the vehicle, system/components, and interface requirements.
Reference
| Number | Title |
|---|---|
| AS568 | AEROSPACE SIZE STANDARD FOR O-RINGS |
| IrDAIrLAP1.1 | This document is not part of the subscrption. |
| IrDAIrPHY1.4 | This document is not part of the subscrption. |
| J2574 | This document is not part of the subscrption. |
| J2574_201109 | Fuel Cell Vehicle Terminology |
| J2578_201408 | Recommended Practice for General Fuel Cell Vehicle Safety |
| J2600_201211 | Compressed Hydrogen Surface Vehicle Fueling Connection Devices |
| J2600_201510 | Compressed Hydrogen Surface Vehicle Fueling Connection Devices |
| J2760 | This document is not part of the subscrption. |
| J2760_201106 | Pressure Terminology Used In Fuel Cells and Other Hydrogen Vehicle Applications |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.