This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Defining Hydraulic Oil Compatibility with Hydraulic Hose Elastomers
- Ground Vehicle Standard
- J2631_200603
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Information Report is intended to provide the hydraulic oil manufacturer and hydraulic equipment manufacturer with information that can be used predicting the relative impact that non petroleum based hydraulic oils may have on the hose elastomers in the existing system. This document contains the information necessary to perform the tests using standard elastomer formulations, representative of material used in hydraulic hose. The test methods used are defined within ASTM D471, standard test method for Rubber Property—Effect of Liquids. The physical properties measured, are volume swell, tensile strength, percent elongation, shore A hardness and load at 100% elongation. The properties were measured, after immersion, at 72 hours, 168 hours, 336 hours, 504 hours, 672 hours, 840 hours, and 1008 hours and the percent calculated as change from the unaged properties. The detail of the testing process is described in the following report.
Rationale
Not applicable.
Recommended Content
Ground Vehicle Standard | Specification for O-Ring Materials Used with Hydraulic Connectors |
Ground Vehicle Standard | Connections for General Use and Fluid Power - Test Methods-Threadless Connections |
Aerospace Standard | Hose and Hose Assembly Selection, Installation, Inspection and Maintenance Guidelines, Listing of |
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Hydraulic Hose and Hose Fittings Committee
The Hydraulic Hose and Hose Fittings Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to hydraulic hose and hose fittings with an intended use in pressure applications. Participants in the FCCTC Hydraulic Hose and Hose Fittings Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
Reference
Number | Title |
---|---|
ASTMD380 | This document is not part of the subscrption. |
ASTMD471 | This document is not part of the subscrption. |
ISO13226 | This document is not part of the subscrption. |
ISO2393 | This document is not part of the subscrption. |
J343_201201 | Test and Test Procedures for SAE 100R Series Hydraulic Hose and Hose Assemblies |
J343_201605 | Test and Test Procedures for SAE 100R Series Hydraulic Hose and Hose Assemblies |
J517_201302 | Hydraulic Hose |
J517_201612 | Hydraulic Hose |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.