This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Metric Nonmetallic Air Brake System Tubing1
- Ground Vehicle Standard
- J1394_200406
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Standard covers the minimum requirements for metric sizes of nonmetallic tubing as manufactured for use in air brake systems. Nonreinforced products are designated type A and reinforced products type B. It is not intended to cover tubing for any portion of the system that operates below −40 °C (−40 °F), above +93 °C (+200 °F), above a maximum working gage pressure of 1.0 MPa (150 psi), or in an area subject to attack by battery acid. This tubing is intended for use in the brake system for connections that maintain a basically fixed relationship between components during vehicle operation. Coiled tube assemblies required for those installations where flexing occurs are covered by this standard and SAE J1131 to the extent of setting minimum requirements on the essentially straight tube and tube fitting connections, which are used in the construction of such assemblies.2
Recommended Content
Ground Vehicle Standard | Nonmetallic Air Brake System Tubing |
Technical Paper | Enhancing the Roller Brake Tester |
Technical Paper | The Effect of “S” Cam Brake Component Variation on Performance |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Air Brake Tubing and Tube Ftg Committee
The Air Brake Tubing and Tube Fittings Committee develops and maintains SAE Standards, Recommended Practices and Information Reports relating to tubing and fittings of air brake systems. Participants in the Air Brake Tubing and Tube Fittings Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee includes OEMs, suppliers, consulting firms, government and other interested parties.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.