This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
SELECTING AND SPECIFYING HOT AND COLD ROLLED STEEL SHEET AND STRIP
- Ground Vehicle Standard
- J126A_197902
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice outlines a procedure for selecting the proper specification for carbon steel sheet and strip which are purchased to make an identified part. Specifications considered are:
It also describes how codes or symbols for specifying certain characteristics may be used in electronic data processing systems. Characteristics covered are:
-
(A)
Hot or cold rolled.
-
(B)
Sheet or strip.
-
(C)
Severity of draw (quality of steel).
-
(D)
Surface condition (finish, etc.).
-
(E)
Edge condition.
-
(F)
Dimensions.
It is intended that other characteristics and part identification be covered by a supplement to the specification, as necessary.
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Reference
Number | Title |
---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.