AS6171/2A Techniques for Suspect/Counterfeit EEE Parts Detection by External Visual Inspection, Remarking and Resurfacing, and Surface Texture Analysis Using SEM Test Methods
Revised
05/11/2017
- Features
- Issuing Committee
- Content
- This document describes the requirements of the following test methods for counterfeit detection of electronic components:
-
a
Method A: General EVI, Sample Selection, and Handling
-
b
Method B: Detailed EVI, including Part Weight measurement
-
c
Method C: Testing for Remarking
-
d
Method D: Testing for Resurfacing
-
e
Method E: Part Dimensions measurement
-
f
Method F: Surface Texture Analysis using SEM
The scope of this document is focused on leaded electronic components, microcircuits, multi-chip modules (MCMs), and hybrids. Other EEE components may require evaluations not specified in this procedure. Where applicable this document can be used as a guide. Additional inspections or criteria would need to be developed and documented to thoroughly evaluate these additional part types. If AS6171/2 is invoked in the contract, the base document, AS6171 General Requirements shall also apply. -
a
- Content
- Counterfeit electronic components frequently have external characteristics that may be used to identify them as suspect. Visual inspection by means of optical and scanning electron microscope (SEM) techniques requires well-defined processes in order to discern and document characteristics that are consistent with counterfeit parts.The published version of AS6171/2 was found to be different from the version that was balloted and approved by the G-19A committee. This revision is needed to address that discrepancy.
- Pages
- 31
- Citation
- SAE International Technical Standard, Techniques for Suspect/Counterfeit EEE Parts Detection by External Visual Inspection, Remarking and Resurfacing, and Surface Texture Analysis Using SEM Test Methods, SAE Standard AS6171/2A, Revised May 2017, Issued October 2016, https://doi.org/10.4271/AS6171/2A.