This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Distribution of Vapor Concentration in a Diesel Spray Impinging on a Flat Wall by Means of Exciplex Fluorescence Method -In Case of High Injection Pressure-
Annotation ability available
Sector:
Language:
English
Abstract
Diesel sprays injected into a combustion chamber of a small sized high-speed CI engine impinge surely on a piston surface and a cylinder wall. As a consequence, their vaporization, mixture formation and combustion processes are affected by impingement phenomena. And the other important factors affecting on the processes is the injection pressure. Then, the distribution of the vapor concentration in a single diesel spray impinging on a flat and hot wall was experimented by the exciplex fluorescence method, as a simple case. The injection pressure was varied in the range from 55 MPa to 120 MPa. It is found that the distribution of the vapor concentration in this case is much leaner than that in the case of the low injection pressure of 17.8MPa.
Authors
Topic
Citation
Fujimoto, H., Kusano, S., and Senda, J., "Distribution of Vapor Concentration in a Diesel Spray Impinging on a Flat Wall by Means of Exciplex Fluorescence Method -In Case of High Injection Pressure-," SAE Technical Paper 972916, 1997, https://doi.org/10.4271/972916.Also In
References
- Katsura, N. Saito, M. Senda, J. Fujimoto, H. “Characteristics of a Diesel Spray Impinging on a Flat Wall” SAE Trans. 98 890264 1989
- Fujimoto, H. Nagae, M. Hashimoto, A. Katsura, N Senda, J. “Characteristics of a Diesel Spray Impinging on a Flat Wall” Proc. COMODIA94 193 198 1994
- Kamimoto, T. Yokota, H. Kobayashi, H. “A New Technique for the Measurement of Sauter Mean Diameter of Droplets in Unsteady Dense Sprays” SAE Paper, No. 890316 1989
- Meiton, L. A. Verdieck, J. F. “Vapor/Liquid Visualization in Fuel Sprays” Proc. 20th Int. Symposium on Combustion 1283 11290 1984
- Meiton, L. A. “Spectrally Separated Fluorescence Emissions for Diesel Fuel Droplets and Vapor” Applied Optics 22 14 2224 2226 1993
- Senda, J. Fukami, Y. Tanabe, Y. Fujimoto, H. “Visualization of Evaporative Diesel Spray Impinging upon Wall Surface by Exciplex Fluorescence Method” SAE Paper, No. 920578 1992
- Senda, J. Kobayashi, M. Tanabe, Y. Fujimoto, H. “Visualization and Quantitative Analysis of the Fuel Vapor Concentration in Diesel Spray” JSAE Review 15 4 149 156 1994
- Senda, J. “Visualization and Quantitative Analysis on Fuel Vapor Concentration in a Diesel Spray” Unsteady Combustion Kluwer Academic Pub. 283 294 1996
- Senda, J. Kobayashi, M. Iwashita, S. Fujimoto, H. “Modeling on Diesel Spray Impinging on Flat Wall” Proc. COMODIA94 411 416 1994
- Senda, J. Kobayashi, M. Iwashita, S. Fujimoto, H. “Modeling of Diesel Spray Impingement on a Flat Wall” SAE Paper, No. 941894 1994
- Senda, J. Kanda, T. Kobayashi, M. Fujimoto, H. “Quantitative Analysis of Fuel Vapor Concentration in Diesel Spray by Exciplex Fluorescence Method” SAE Paper, No. 970796 1997
- Fujimoto, H. Sato, G. T. Kuniyoshi, H. Ishii, Y. Endo, Y. “Investigation on Combustion in Medium-Speed Marine Diesel Engines Using Model Chambers” Proc.12ch CIMAC 1853 1900 1977
- Kamimoto, T. Yokota, H. Kobayashi. H. “Effect of High Pressure Injection on Soot Formation in a Rapid Compression Machine to Simulate Diesel Flames” SAE Paper, No. 871610 1987
- Felton, P.G. Bracco, F.V. Bardsley, M.E.A. “On the Quantitative Application of Exciplex Fluorescence to Engine sprays” SAE paper, No.930870 1993
- Yeh, C.N. Kamimoto, T. Kosaka, H. Kobori, S. “Quantitative Measurement in a Transient Spray via Laser-Induced Fluorescence Technique” SAE Paper, No. 941953 1994
- Rotunno, A.A. Winter, M. Dobbs, G.M. Melton L.A. “Direct Calibration Procedure for Exciplex-Based Vapor/liquid Vaporization of Fuel Sprays” Combustion Science and Technology 71 247 261 1990
- Fujimoto, H. Senda, J. Nagae, M. Hashimoto, A. “Characteristics of a Diesel Spray Impinging on a Flat Wall” Proc. COMODIA 90 193 198 1990