This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Simultaneous Prediction of Pressure Losses and Acoustic Characteristics in Silencers by Numerical Simulation
Annotation ability available
Sector:
Language:
English
Abstract
A practical method has been developed for numerically predicting pressure losses and acoustic characteristics in silencers simultaneously under the quasi-operating conditions of internal combustion engines. In the present method, three-dimensional gas flow and pressure dynamics in silencers have been numerically simulated by means of a new three-dimensional non-linear fluid-dynamic model, where the gas exchange process in entire intake and exhaust systems has been calculated by a one-dimensional non-linear fluid-dynamic model for saying the computing time. In this three-dimensional fluid-dynamic model, an accurate numerical scheme with less numerical diffusion has been applied to the Reynolds average Navier-Stokes equations using an eddy-viscosity hypothesis. Pressure losses and insertion losses in silencers have been examined using the three-dimensional model. It has been shown that the present method can predict the pressure losses and acoustic characteristics simultaneously.
Recommended Content
Technical Paper | Modeling the Exhaust System in Two-Stroke Small Engines |
Technical Paper | Throttle Flow Characterization |
Technical Paper | Effect of a Perforated Resonator on the Flow Performances of the Turbocharged Intake System for a Diesel Engine |
Topic
Citation
Isshiki, Y., Shimamoto, Y., and Wakisaka, T., "Simultaneous Prediction of Pressure Losses and Acoustic Characteristics in Silencers by Numerical Simulation," SAE Technical Paper 960637, 1996, https://doi.org/10.4271/960637.Also In
References
- JSME Mechanical Engineers' Handbook - C8: Environmental Equipment The Japan Society of Mechanical Engineers Tokyo 1989
- Cheng-I, J. Y. Crocker, M. J. “Prediction of Transmission Loss in Mufflers by the Finite-Element Method” J. Acoust. Soc. of America 57 1 144 148 1975
- Tanaka, T. Fujikawa, T. Abe, T. Utsuno, H. “A Method for the Analytical Prediction of Insertion Loss of a Two-Dimensional Muffler Model Based on the Transfer Matrix Derived from the Boundary Element Method” J. Vib. Acoust. Stress Reliab. Des., Trans. ASME 107 1 86 91 1985
- Seybert, A. F. Cheng, C. Y. R. “Application of the Boundary Element Method to Acoustic Cavity Response and Muffler Analysis” J. Vib. Acoust. Stress Reliab. Des., Trans. ASME , 109 1 15 21 1987
- Shimamoto, Y. Oka, M. Tanaka, Y. “A Research of Inertia Charging Effect of Intake System in Multi-Cylinder Engines” Bull. Japan Soc. Mech. Engr. 21 153 502 510 1978
- Blair, G. P. Spechko, J. A. “Sound Pressure Levels Generated by Internal Combustion Engine Exhaust Systems” SAE Paper 720155 1972
- Nishiwaki, K. Shimamoto, Y. “Prediction of Exhaust Noise Level in Internal Combustion Engines - 1st Report, Basic Study under Motored Condition in Single-Cylinder Engine with Straight Exhaust Pipe System” Trans. Japan Soc. Mech. Engr. 44 377 250 259 1978
- Nishiwaki, K. Shimamoto, Y. “Prediction of Exhaust Noise Level in Internal Combustion Engines - 2nd Report, Study under Firing Condition in Two-Cylinder Engine with Silencer of Double-Expansion Chamber Type” Trans. Japan Soc. Mech. Engr. 1587 1598 1979
- Petrak, P Poloni, M. “Exhaust System Noise Optimization using Mathematical Modelling” Proc. IMechE Conf, on Computers in Engine Technology 111 117 1991
- Morel, T. Morel, J. Blaser, D. A. “Fluid Dynamic and Acoustic Modeling of Concentric-Tube Resonators/Silencers” SAE, Paper 910072 1991
- Takayama, K. Onodera, O Sekine, N. Ito, K. Matsumura, S. “Shock Wave Development and Propagation in automobile Exhaust Systems” SAE Paper 880082 1988
- Giannattasio, P. Dadone, A. “Applications of a High Resolution Shock-Capturing Scheme to the Unsteady Flow Computation in Engine Ducts” Proc. IMechE Conf. on Computers in Engine Technology 119 126 1991
- Zhao, Y. Winterbone, D. E. “Numerical Simulation of Multi-Dimensional Flow and Pressure Dynamics in Engine Intake Manifolds” Proc. IMechE Conf. on Computers in Engine Technology 47 55 1991
- Isshiki, Y. Shimamoto, Y. Wakisaka, T. “Estimation of the differences of Swirl and Charging Characteristics between Cylinders in a Multi-Cylinder Diesel Engine” Proc. IMechE Cong. EUROTECH DIRECT '91 109 118 1991
- Takewaki, H. Nishiguchi, A. Yabe, T. “Cubic Interpolated Pseudo-particle Method (CIP) for Solving Hyperbolic-Type Equations” J. Comput. Phys. 61 261 268 1985
- Takewaki, H. Yabe, T. “The Cubic-Interpolated Pseudo Particle (CIP) Method: Application to Nonlinear and Multi-dimensional Hyperbolic Equations” J. Comput. Phys. 70 355 372 1987
- Yabe, T. Takei, E. “A New Higher-Order Godunov Method for General Hyperbolic Equations” J. Phys. Soc. Japan 57 8 2598 2601 1988
- Oda, T. Shimamoto, Y. Kanamaru, K. “Numerical Analysis of Gas Flows in Intake and Exhaust Systems by Double Mesh Method” JSAE Review , 13 3 16 21 1992
- Obata, T. Hirata, M. “Estimation on Acoustic Power of Flow-Generated Noise and on Head Losses of Silencers” J. Acoust. Soc. Japan 34 9 532 540 1978
- Cloutman, L. D. Dukowicz, J. K. Ramshaw, J. D. Amsden, A. A. “CONCHAS-SPRAY: A Computer Code for Reactive Flows with Fuel Sprays” Report LA-9294-MS Los Alamos National Laboratory 1982
- Deardorff, J. W. “A Numerical Study of Three-Dimensional Turbulent Channel Flow at Large Reynolds Numbers” J. Fluid Mech. 41 2 453 480 1970
- Obayashi, S Kuwahara, K “Numerical Method for the Compressible Navier-Stokes Equations” Nagare 5 2 130 146 1986
- Amsden, A. A. Ramshaw, J. D. O'Rourke, P. J. Dukowicz, J. K. “KIVA: A Computer Program for Two- and Three-Dimensional Fluid Flows with Chemical Reactions and Fuel Sprays” Report LA-10245-MS Los Alamos National Laboratory 1985
- Isshiki, Y. Shimamoto, Y. Wakisaka, T. Kubota, K. “Prediction of the Effects of Inserted Pipes on the Characteristics of Silencers” Proc. of the 253rd Meeting of Japan Soc. Mech. Engr. Kansai Branch 243 245 1994
- Isshiki, Y. Shimamoto, Y. Wakisaka, T. Akagi M. “A Numerical Method for Predicting Sound Characteristics and Pressure Losses of Silencers in Internal Combustion Engine” Trans. Japan Soc. Mech. Engr. 3507 3512 1992
- Idelchik, I. Handbook of Hydraulic Resistance 3rd CRC Press 1994
- Morse, P. M. Ingard, K. U. Theoretical Acoustics McGraw-Hill New York 1968