This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Chaos Analysis on In-Cylinder Pressure Measurements
Annotation ability available
Sector:
Language:
English
Abstract
Peak pressure, crank angle and induction pressure were measured in cylinder number one of a Ford 4.6 liter Modular engine. Chaos analysis was conducted on these measurements and the phase, waveform, Poincare, and FFT plots are presented. These plots show conclusively that the pressure fluctuation inside a cylinder is a broadband chaos.
Recommended Content
Authors
Topic
Citation
Chew, L., Hoekstra, R., Nayfeh, J., and Navedo, J., "Chaos Analysis on In-Cylinder Pressure Measurements," SAE Technical Paper 942486, 1994, https://doi.org/10.4271/942486.Also In
References
- Brands, M.C. “Helmholtz Tuned Induction System for Turbocharged Diesel Engine,” SAE Paper 790069 1979
- Vorum, P.C. “Short Pipe Manifold Design for Four Stroke Engine,” ASME Paper 76-WA/DGP-4 New York 1976
- Bulaty, T. Niessner, H. “Calculation of Unsteady Flow in Pipe Systems of I.C. Engines,” ASME paper, ASME-WA7 1984
- Todd, T. “Experimental Determination of the Causes of Induction Noise in Four-Cylinder Engines” Pennsylvania State University, Department of Mechanical Engineering 1986
- Morse, P.M. Boden, R.H. Schecter, H. “Acoustics Vibrations and Internal Combustion Engine Performance,” Journal of Applied Physics 9 1938 16 23
- Engelman, H.W. “Design of Tuned Intake Manifold,” ASME Paper 73-WA/DGP-2 Detroit, Michigan Nov. 11-15 1973
- List, Hans “Increasing the Volumetric Efficiency of Diesel Engines by Intake Pipes,” NACA Technical Memorandum 700 March 1933
- Valentino, G. Kaufman, D. Farrell, P. “Intake Valve Flow Measurements Using PIV,” SAE Paper 932700 Fuel and Lubricants Meeting and Exposition Philadelphia, Pennsylvania Oct. 18-21 1993
- Acroumanis, C. Whitelaw, J.H. “Fluid Mechanics of Internal Combustion Engines- A Review,” Inst of Mechanical Engineer 201 C1 57 74 1987
- Heywood, J.B. Internal Combustion Engines Fundamentals McGraw Hill 1988
- Vafidis, C. Vorropoulos, Whitelaw J.H. “Effects of Intake Port and Combustion Chamber Geometry on In-Cylinder Turbulence in Motored Reciprocating Engine,” Symposium on Fluid Flow and Heat Transfer in Reciprocating Machinery ASME Winter Annual Meeting Boston, MA Dec. 1987
- Groff, E.G. Matekunas F.A. “The Nature of Turbulent Flame Propagation in a Homogeneous Spark-Ignited Engine,” SAE Paper No. 800133 1980
- Liou, T.M. Santivicca, D.A. Bracco F.V. “Turbulence Measurements in a Ported Engine,” International Symposium on Applications of Laser-Doppler Anemometry of Fluid Mechanics Lisbon, Portugal 1982
- Gosman, A.D. Tsui Y.Y. Vafidis C. “Flow in a Model Engine With a Shrouded Valve- A Combined Experimental and Computational Study,” SAE Paper No. 850498 1985
- Thompson, P.M. Engelman, H.W. “The Two Type of Resonance in Intake Tuning ASME paper 69-DGP-11 April 20-24 1969
- Taylor, C.F. Livengood, J.C. Tsai, D.H. “Dynamics in the Inlet System of a Four-Stroke Single-Cylinder Engine,” ASME Transaction 77 Oct. 1955 1133 1145
- Baker, G.L. Gollub, L.P. Chaotic Dynamics, An Introduction Cambridge University Press 1990