This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effect of Forcing a “Worst Case Vehicle Configuration” on Drive-By Noise Results Using Test Procedure SAE J986OCT88
Annotation ability available
Sector:
Language:
English
Abstract
The effect of adjusting the kick-off speed to attain a “worst case vehicle configuration” on drive-by noise measurements using test procedure SAE J986OCT88 was investigated. It was determined that similar noise results were obtained for both the “forced worst-case” vehicle and the actual worst-case vehicle. This information is a useful development tool due to the fact that a wide variety of axle ratios, tires, and transmissions are available as options on light duty trucks, making it difficult to determine or obtain the actual worst-case vehicle. Forcing the worst-case configuration allows for the testing of vehicles when the exact worst case vehicle is not available.
Authors
Topic
Citation
Hall, G., Courtley, D., and Sloss, J., "Effect of Forcing a “Worst Case Vehicle Configuration” on Drive-By Noise Results Using Test Procedure SAE J986OCT88," SAE Technical Paper 933040, 1993, https://doi.org/10.4271/933040.Also In
References
- Hillquist, R.K. “Development of an Exterior Sound Level Measurement Procedure for Light Motor Vehicles - SAE J986” SAE Paper 800440
- Daniels, V.A. Veres, R.E. “The Fourier Transform Applied to Vehicle Exterior Noise Source Identification” SAE Paper 760151
- Paddy, R.H. “An Evaluation of Light Vehicle Exterior Noise Test Procedures” SAE Paper 810400
- Cherne, K.D. “Motor Vehicle Noise Regulations” SAE Paper 931281
- “Vehicle Noise Measurement System” operating manual Ford Motor Company