This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of Simulation Model for Calculating Loads to Synchronous Drive Belt
Annotation ability available
Sector:
Language:
English
Abstract
A simulation model has been developed to estimate belt load by replacing the L/O (layout) around the engine synchronous drive belt and cam pulley with a simple vibration model based on the spring-mass system. Different engine specifications were applied to compare belt load estimates made by this model with the load actually measured, and found that the estimates matched the measurement values precisely. This report describes the specifications of our simulation model and the results of verification.
Recommended Content
Authors
Topic
Citation
Uchida, T., Hanada, N., Furukawa, Y., and Tomono, K., "Development of Simulation Model for Calculating Loads to Synchronous Drive Belt," SAE Technical Paper 930622, 1993, https://doi.org/10.4271/930622.Also In
References
- Mizuno Naohiko Inagaki Hiroshi et al. “Analysis of synchronous drive belt motion” JSAE Proceedings 871, Paper No. 871010 51 56 1987
- Sato T. Shoda K. Furukawa T. Nakmura Y. Yamaguchi M. “Analysis of Timing Belt Tension with Simulation Modeling” JSAE 45 11 1991 81 85
- Kiyohisa Tomono Takanao Uchida et al “Direct measuring method cord dynamic stress on an automotive synchronous belt” JSAE Review Oct 1992 13 4
- Yuichi Murakami Masahiko Watanabe et al “Study of Belt Toughness Through an Examination of the Strain on Belt Cords” SAE Technical Paper 880415
- JSME Mechanical Engineers- Handbook, Fundamentals, Applications, 1987 Sec.'A3 Mechanics and Mechanical Vibration-
- Amijima Sadao Fujii Toru “Tooth load distribution of synchronous drive belt” JSME Trans 42 2233 2241 1976
- Masanori Kagotani Tomio Koyama et al “Load distribution of synchronous drive belt at initial tension” JSME Trans 49 2212 2219 1983
- Tomio Koyama Masanori Kagotani et al “Study on strength of synchronous drive belt (No.1)” JSME Trans 44 312 320 1978
- Reinicke-Murmann J. Kreuter P. ”Analysis and Development of Camshaft Drive Systems Using a Computer Simulation Model” SAE Technical Paper 900448 1990
- Uchida T. Yamaji Y. Hanada N. “The Analysis of a Load on Each Tooth of 4 Cycle Gasoline Engine's Cam Pulley” MPT-91(JSME) in Hiroshima Japan