This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Spring Back of Radial Shaft Seals with Rubber OD
Annotation ability available
Sector:
Language:
English
Abstract
The phenomenon of the spring back of radial shaft seals with rubber covered OD, looking for the first glance as a marginal one, should not be ignored during the seal design. From the numerical analysis of the installation process supplemented with experimental data results a considerable influence of the front part of the rubber layer covering the seal case on the run of tangential force and spring back. It will be shown that it is possible by proper design of the rubber layer on OD to counteract the spring back of the seal.
Authors
Citation
Gawlinski, M., Konderla, P., and Upper, G., "Spring Back of Radial Shaft Seals with Rubber OD," SAE Technical Paper 920717, 1992, https://doi.org/10.4271/920717.Also In
References
- Knott H.J. “Solutions of thermal Expansion of Aluminium Seal Housings” SAE Paper 841147
- Gerulski M. “Analysis of Radial Lip Seal Case Press Fit in Aluminium Housings” SAE Paper 900336
- Jackowski R. et al “Advanced Elastomeric Seal Design and Material for Automotive Crankshaft Applications” SAE Paper 870507
- Gawlinski M. Konderla P. “Contact Problems Formulated by Means of Boundary Element Method “10th Polish Conference on Computer Methods in Mechanics” 197 204