This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Aerodynamic Drag Implications of Exterior Truck Mirrors
Annotation ability available
Sector:
Language:
English
Abstract
Until recently, the aerodynamic design of large transport trucks has often ignored an important contribution to drag caused by the accessory rearview mirrors.
In this study, three commercially available truck mirrors are tested full-scale in a wind tunnel at highway speeds. The actual drag forces and the coefficients of drag based on frontal and glass areas are compared for various mirror angles, with and without a convex-mirror attachment. All three mirror types produced significantly high drag forces which were used to estimate the fuel consumption attributed to mirror aerodynamic resistance.
A standard rearview mirror, with mounting brackets, set was found to exhibit a drag coefficient, based on the glass area, of 1.81, which would increase the drag of a typical (Cd = 0.7, Af = 4.5m2) truck by about 8.5 percent. A teardrop-shaped accessory mirror, although appearing more streamlined, actually produced a higher glass-based drag coefficient of 1.94, adding about 10 percent to the truck drag. A recent fully-faired mirror set performed best, with a glass-area-based drag coefficient of only 1.13, making up only 5.3 percent of the typical total aerodynamic truck drag.
Comparing the energy implications of the best to the worst mirrors, the estimated saving in fuel based on 150,000 km of annual driving, could amount to 800 L of diesel fuel or 1250 L of gasoline. These results suggest that more attention needs to be paid to truck-mirror aerodynamic design and selection.
Recommended Content
Citation
Cresswell, M. and Hertz, P., "Aerodynamic Drag Implications of Exterior Truck Mirrors," SAE Technical Paper 920204, 1992, https://doi.org/10.4271/920204.Also In
Vehicle Aerodynamics: Wake Flows, Computational Fluid Dynamics, and Aerodynamic Testing
Number: SP-0908; Published: 1992-02-01
Number: SP-0908; Published: 1992-02-01
References
- Hucho, W. “Aerodynamics of Road Vehicles” Butterworth & Co. 0-408-01422-9 1987
- Fitch, J.W. “Motor Truck Engineering Handbook” 3rd 1984
- Remenda, B.A.P. Hertz, P.B. “Comparison, Selection and Modelling of Small Power Plants for the Nexus Vehicle” University of Saskatchewan Vehicle Research Group Society of Automotive Engineers Technical Paper Series No. 880270 1988 SAE Transactions 1989
- Bosch Automotive Handbook 2nd 1986
- Muto, S. “Automobile Aerodynamics: Car Styling 50.5 Special Issue” San'ei Shobo Tokyo 160, Japan June 1986