This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Toyota Air-Mix Type Two-Hole Injector for 4-Valve Engines
Annotation ability available
Sector:
Language:
English
Abstract
An air-mix type 2-hole injector has been developed for 4-valve engines. In order to finely atomize the fuel whilst maintaining the separation of the twin sprays that assures minimal wetting of the partition between the siamese ports, the location of the air inlet passages was optimized and studies were conducted to determine the appropriate geometry of the fuel separation portion of the adapter. High speed photographs verify that the finalized adapter realizes centralized fuel flow through the splayed conduits so that the maximum air entrainment is achieved.
This new injector both improves transient response and reduces HC emissions under all temperature conditions. It further enables injection timing to be retarded to the intake stroke at the same low HC level.
Authors
Topic
Citation
Sugimoto, T., Takeda, K., and Yoshizaki, H., "Toyota Air-Mix Type Two-Hole Injector for 4-Valve Engines," SAE Technical Paper 912351, 1991, https://doi.org/10.4271/912351.Also In
References
- Iwata M. Furuhashi M. Ujihashi M. “Two-hole Injector Improves Transient Performance and Exhaust Emissions of 4-valve Engines” SAE Paper 870125
- Swithenbank J. et al. “A laser diagnostic technique for the measurement of droplet size distribution” Progress in Astronautics and Aeronautics vol.53, Experimental Diagnostics in Gas Phase Combustion Systems 1977
- Nakayama M. Ohgiwara G. “On the study of spray characteristics by Fraunhofer diffraction method” The 10th Conference on Liquid Atomization and Spray Systems Japan 59 62 1982
- Hamburg D.R. David Klick “The Measurement and Improvement of the Transient A/F Characteristics of an Electronic Fuel Injection System” SAE Paper 820766
- Aquino Charies F. Fozo S.Robert “Steady-state and Transient A/F Control Requirements for Cold Operation of a 1.6 liter Engine with single Point Fuel Injection” SAE Paper 850509
- Nogi T. Ohyama Y. Yamauchi T. “Effects of Mixture Formation of Fuel Injection Systems in Gasoline Engine” SAE Paper 891961
- Matsumoto Y. “Analytical and experimental investigations of jets of two dimensions deflected by various wall surfaces” Journal of JSME 30 122 257 294 1927