This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Analysis and Design of Threaded Assemblies
Annotation ability available
Sector:
Language:
English
Abstract
A model to precisely predict the load and mode of failure of threaded assemblies has been developed. The analysis is applicable to any assembly of the ISO R68 or Unified thread form, of which pertinent dimensional and mechanical properties are known. These techniques have been extended to provide a method for design of assemblies, and appropriate testing standards for the product.
Recommended Content
Authors
Topic
Citation
Alexander, E., "Analysis and Design of Threaded Assemblies," SAE Technical Paper 770420, 1977, https://doi.org/10.4271/770420.Also In
References
- Alexander E. M. “Design and Strength of Screw Threads.” Transactions of Conference on Metric Mechanical Fasteners American National Metric Council Conference Washington 1975
- Gill P. “The Static Strength of Screw Threads.” G.K.N.
- Ellison H. W. “Effect of Nut Geometry on Nut Strength.” General Motors Corporation Warren, Michigan 1970
- “Formula for Calculating the Stripping Strength of Internal Threads in Steel.” Report to ISO/TC1/WG4 Sweden-Bultfabriks AB
- Parisen J. D. “Length of Thread Engagement into Nodular Iron.” General Motors Corporation Warren, Michigan 1969
- Wiegand H. Illgner K. H. 1967
- Fleischer N. F. Strelow D. “Stripping Strength of Cold Forged Nuts Made from Unalloyed Low Carbon Steel.” March 1975