This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Dynamic Modeling of a Diesel Oxidation Catalyst and Diesel Particulate Filter Aftertreatment System for Regeneration Control Development
Technical Paper
2017-32-0105
ISSN: 0148-7191, e-ISSN: 2688-3627
This content contains downloadable datasets
Annotation ability available
Sector:
Language:
English
Abstract
The main function of diesel particulate filter (DPF) is to remove the particulate matter (PM) from diesel engine emission. However, the accumulated PM restricts the exhaust flow through the DPF and increases the back pressure which may negatively impact fuel consumption. Therefore, the particulate filter needs to be regenerated by burning off the accumulated particulate, which is achieved either by passively use of a catalyst or by actively introducing high heat into the exhaust system.
In the exhaust after treatment system considered in this paper, a diesel oxidation catalyst (DOC) is installed upstream of the DPF to facilitate the regeneration process. In order to combust the captured particulate in the DPF, a small amount of fuel can be injected into the exhaust, upstream of the DOC, when necessary. In an effort to develop a model-based control strategy which completes the regeneration while satisfies the constraints such as fuel consumption, temperature and regeneration period, a physics-based dynamic model of the DOC-DPF exhaust after treatment system is proposed. Parameters in the model including the heat transfer coefficient, reaction constants in the DOC and DPF, and the permeability of the filter and soot are identified based on the experimental measurements. The DOC-DPF model is then validated both at steady state and during transient against experimental data measured at various engine operating conditions, PM loads and fuel injection rates.
Recommended Content
Authors
- C. J. Chiang - National Taiwan University of Science and Technology
- T. F. Kuo - National Taiwan University of Science and Technology
- Anton Halim - National Taiwan University of Science and Technology
- S. C. Cheng - National Taiwan University of Science and Technology
- Y.Y. Ku - National Taiwan University of Science and Technology
Topic
Citation
Chiang, C., Kuo, T., Halim, A., Cheng, S. et al., "Dynamic Modeling of a Diesel Oxidation Catalyst and Diesel Particulate Filter Aftertreatment System for Regeneration Control Development," SAE Technical Paper 2017-32-0105, 2017, https://doi.org/10.4271/2017-32-0105.Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 | ||
Unnamed Dataset 3 | ||
Unnamed Dataset 4 | ||
Unnamed Dataset 5 | ||
Unnamed Dataset 6 |
Also In
References
- The new generation of diesel engines May 2007 taiwan Maruboshi Information Technology Co., Ltd.
- http://air.epa.gov.tw Environmental Protection Department of the Executive Yuan / Fine Particulate Matter Control
- Pinturaud D. , Charlet A. , Caillol C. , and Higelin P. Experimental study of dpf loading and incomplete regeneration SAE International
- Kuki T. , Miyairi Y. , Kasai Y. , Miyazaki M. , and Miwa S. Study on reliability of wall-flow type diesel particulate filter SAE International
- Konstandopoulos A. G. , Kladopoulou E. A. , H.J. S. L. , and Parker G. G. A study describing the performance of diesel particulate filters during loading and regeneration a lumped
- Guzzella L. and Onder C.H. Introduction to Modeling and Control of Intermal Combustion Engine Systems Springer 2004
- http://www.dieselnet.com diesel Net
- Sharma H.N. , Pahalagedara L. , Joshi A. , Suib S.L. , and Mhadeshwar A.B. Experimental study of carbon black and diesel engine soot oxidation kinetics using thermogravimetric analysis American Chemical Society