Try Mobilus Beta
Search tips
 This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Hole Drilling With Orbiting Motion for Residual Stress Measurement – Effects of Tool and Hole Diameters

Journal Article
2017-01-0400
ISSN: 1946-3936, e-ISSN: 1946-3944
DOI: https://doi.org/10.4271/2017-01-0400
Published March 28, 2017 by SAE International in United States
Hole Drilling With Orbiting Motion for Residual Stress Measurement – Effects of Tool and Hole Diameters
Sector:
Citation: Rickert, T., "Hole Drilling With Orbiting Motion for Residual Stress Measurement – Effects of Tool and Hole Diameters," SAE Int. J. Engines 10(2):467-470, 2017, https://doi.org/10.4271/2017-01-0400.
Language: English

Abstract:

Hole drilling is a very common technique for measuring residual stresses. Adding an orbiting motion of the drill was found to improve hole quality in difficult to drill materials and has been in practice for decades. This study compares measurements using various orbiting amounts. Each measurement was repeated twice to evaluate measurement statistics. There is a distinct, though relatively small, effect of the hole shape when no orbiting is used. It disappears already when the hole is 50% larger than the tool size. Different orbiting amounts also produce systematically different results. These may be related to the absolute hole size.

Recommended Content

Technical Paper Machinability of MADI™
Technical Paper MPAC (Multi Panel Assembly Cell)
Aerospace Standard Adapters - Port Connection, Ring Locked Design, Installation and Removal of