This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Numerical Analysis of In-Cylinder Flow in a Single Cylinder Research Engine with Variable Compression Ratio
Technical Paper
2016-36-0345
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In this work, the in-cylinder flow of a spark ignited Single Cylinder Research Engine (SCRE) with variable compression ratio was simulated using STAR-CD, a Computational Fluid Dynamics (CFD) software with es-ice module for internal combustion engines. The engine used in this work was an AVL SCRE with 82 mm bore and 86 mm stroke. The simulations were made in two different configurations, one with a piston suited for wall guided direct injection and a steel liner (Configuration 1) and another with flat piston and a transparent liner (Configuration 2). Configuration 1 was simulated with the compression ratios of 9.3:1, 11.5:1 and 12.0:1 and had its in-cylinder values of tumble, Turbulent Kinetic Energy (TKE), pressure and temperature analyzed and compared between compression ratios. Configuration 2 was used for validation of in-cylinder flow field using Particle Image Velocimetry (PIV) measurements and experimental in-cylinder pressure. Both configurations were simulated for 1000 RPM. The validation comparing simulation and experimental results showed an average and maximum difference of in-cylinder pressure of 2% and 7% respectively and an average and maximum difference of mean velocity at the visualization window of 12% and 18% respectively. Very small differences were observed in the tumble coefficients and TKE levels between compression ratios while temperature and pressure increased as expected with increasing compression ratio.
Recommended Content
Authors
- Paulo Henrique Terenzi Seixas - Federal University of Minas Gerais
- Bruno Vieira Silva - Federal University of Minas Gerais
- Raphael Meireles Braga - Federal University of Minas Gerais
- Leonardo Mayer Reis - Federal University of Minas Gerais
- Ramon Molina Valle - Federal University of Minas Gerais
- Rudolf Huebner - Federal University of Minas Gerais
Citation
Seixas, P., Silva, B., Braga, R., Reis, L. et al., "Numerical Analysis of In-Cylinder Flow in a Single Cylinder Research Engine with Variable Compression Ratio," SAE Technical Paper 2016-36-0345, 2016, https://doi.org/10.4271/2016-36-0345.Also In
References
- Li , Y. , Zhao , H. , Peng , Z. , and Ladommatos , N. Analysis of Tumble and Swirl Motions in a Four-Valve SI Engine SAE Technical Paper 2001-01-3555 2001 10.4271/2001-01-3555
- Lumley , L.J. Engines, an Introduction Cambridge University Press Cambridge 1999
- Hill , P. G. ; Zhang , D. The effect of swirl and tumble on combustion in spark ignition engines Progress in Energy and Combustion Science 20 5 373 429 1994 10.1016/0360-1285(94)90010-8
- Aita , S. , Tabbal , A. , Munck , G. , Montmayeur , N. et al. Numerical Simulation of Swirling Port-Valve-Cylinder Flow in Diesel Engines SAE Technical Paper 910263 1991 10.4271/910263
- Wheeler , J. , Polovina , D. , Ramanathan , S. , Roth , K. et al. Increasing EGR Tolerance using High Tumble in a Modern GTDI Engine for Improved Low-Speed Performance SAE Technical Paper 2013-01-1123 2013 10.4271/2013-01-1123
- Le Coz , J. , Henriot , S. , and Pinchon , P. An Experimental and Computational Analysis of the Flow Field in a Four-Valve Spark Ignition Engine-Focus on Cycle-Resolved Turbulence SAE Technical Paper 900056 1990 10.4271/900056
- Fansler , T. and French , D. Cycle-Resolved Laser-Velocimetry Measurements in a Reentrant-Bowl-in-Piston Engine SAE Technical Paper 880377 1988 10.4271/880377
- Rouland , E. , Trinité , M. , Dionnet , F. , Floch , A. et al. Particle Image Velocimetry Measurements in a High Tumble Engine for In-Cylinder Flow Structure Analysis SAE Technical Paper 972831 1997 10.4271/972831
- Choi , K. , Park , J. , Lee , N. , Yu , C. et al. A Research on Fuel Spray and Air Flow Fields for Spark-Ignited Direct Injection using Laser Measurement Technology SAE Technical Paper 1999-01-0503 1999 10.4271/1999-01-0503
- Reuss , D. Cyclic Variability of Large-Scale Turbulent Structures in Directed and Undirected IC Engine Flows SAE Technical Paper 2000-01-0246 2000 10.4271/2000-01-0246
- Kurniawan , W. H. ; Abdullah , S. ; Shamsudeen , A. A computational fluid dynamics study of cold-flow analysis for mixture preparation in a motored four-stroke direct injection engine Journal of applied sciences 7 19 2007 2724 2007
- Versteeg , H. ; Malalasekera , W. An Introduction to Computational Fluid Dynamics: The Finite Volume Method 2a Prentice Hall 2007 520
- Chen , A. , Veshagh , A. , and Wallace , S. Intake Flow Predictions of a Transparent DI Diesel Engine SAE Technical Paper 981020 1998 10.4271/981020
- Payri , F. ; Benajes , J. ; Margot , X. ; Gil , A. CFD modeling of the in-cylinder flow in direct-injetion diesel engines Computers & Fluids 33 8 995 1021 2004 10.1016/j.compfluid.2003.09.003
- Toh , H. , Huang , R. , Lin , K. , and Chern , M. Computational Study on the Effect of Inlet Port Configuration on In-Cylinder Flow of a Motored Four-Valve Internal Combustion Engine J. Energy Eng. 137 4 198 206 2011 10.1061/(ASCE)EY.1943-7897.0000044
- Qi , Y.L. ; Dong , L.C. ; Liu , H. ; Puzinauskas , P.V. and Midkiff , K.C. Optimization of intake port design for SI engine International Journal of Automotive Technology 13 6 861 872 2012 10.1007/s12239-012-0088-2
- Yakhot , V. , Orszag , S.A. , Thangam , S. , Gatski , T.B. & Speziale , C.G. 1992 Development of turbulence models for shear flows by a double expansion technique Physics of Fluids A 4 7 1510 1521 10.1063/1.858424
- Gomes , C. , da Costa , R. , Franco , R. , Valle , R. et al. PIV Measurements of In-Cylinder Tumble Flow in a Motored Single Cylinder Optical Research Engine SAE Technical Paper 2015-36-0305 2015 10.4271/2015-36-0305
- CD-ADAPCO STAR-CD Version 4.20: User Guide ES-ICE CD-adapco 2013