This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Pressure Control Method of Hydraulic Retarder Working Chamber
Technical Paper
2016-01-8119
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In order to overcome hysteresis and dead zone problems caused by friction for the proportional solenoid valve, and improve rapidity and stability of the pneumatic system on hydraulic retarder, a closed-loop control strategy based on valve coil current was proposed. The high-frequency low-amplitude dither signal was introduced into the proportional solenoid valve. With the proper dither signal, the stick-slip motion of the valve core was transformed into a steady one, and its dynamic performance was improved. Consequently, response time of retarder was reduced during gear changing. The proportional valve coil current was measured as a feedback for a closed-loop control strategy. Combining with the closed-loop strategy, the PI control algorithm was adopted to make sure that valve current was in accordance with the target value. Pulse Width Modulation (PWM) signal was used for the driving of proportional solenoid valve. By changing the duty ratio of PWM, the superposition of dither signal and the control of proportional valve coil current were achieved. Platform-experiment was implemented at end. The results showed that, the pneumatic system of retarder output braking pressure rapidly and stably under different gears.
Authors
Citation
Sun, J., Pei, X., Guo, X., and Zhao, Y., "Pressure Control Method of Hydraulic Retarder Working Chamber," SAE Technical Paper 2016-01-8119, 2016, https://doi.org/10.4271/2016-01-8119.Also In
References
- Ming , X. , and Huiyuan , L. Research on Constant Torque Control System Design for Hydraulic Retarder of Heavy Vehicle Advanced Materials Research 2493 2499 2012
- VOITH http://voith.com/en/index.html Jan. 2016
- Helmut , S. , Heinz , K. , and Bernhard , R. ZF Retarder in Commercial Vehicles SAE Technical Paper 922452 1992
- Cooney , T. and Mowatt , J. Development of a Hydraulic Retarder for the Allison AT545R Transmission SAE Technical Paper 952606 1995 10.4271/952606
- Zhou , Q. Studies on the Electro-hydraulic Proportional Control Technology on Charging and Discharging of Vehicular High Power Hydraulic Retarder Ph.D. thesis Beijing Institute of Technology 2013
- Juntao , C. , Bin , L. , Wen , B. , Wenyu , N. et al. Ducted Rockets Based on Adaptive Dither Method Journal of Aerospace Engineering 26 4 715 720 2013
- Jiseong , J. , and Junghoan , B. A Method of Accurate Position Control with a Pneumatic Cylinder Driving Apparatus Journal of Mechanic Science and Technology 20 7 993 1001 2006
- Barreiro , A. , Banos , A. , Gordillo , F. , and Aracil , J. Nonlinear problems in friction compensation Lecture Notes in Control and Information Sciences 273 117 130 2002
- Zhu , Y. , and Tang X. Dither Algorithm in Pulse Width Modulation JOURNAL OF MECHANICAL ENGINEERING 45 4 214 218 2009
- Shih , M. , and Ma , M. Position Control of a Pneumatic Rodless Cylinder Using Sliding Mode M-D-PWM Control the High Speed Solenoid JSME International Journal Series C 41 2 236 241 1998
- Shih , M. , Ma , M. Position Control of a Pneumatic Rodless Cylinder Using Fuzzy PWM Control Method Mechatronics 41 2 241 253 1998
- Qirui , X. , and Guo , W. Characteristic Analysis and Control for High Speed Proportional Solenoid Valve IEEE Conference on Industrial Electronic and Applications 2013 Australia June 19-21, 2013
- Kyoungkwan , A. , and Shinichi , Y. Intelligent Switching Control of Pneumatic Actuator Using on/off Solenoid Valves Mechatronics 15 683 702 2005
- SHI , D. Research on the Impact and Suppression of the Cylinder Friction in Pneumatic Position Ph.D. thesis Harbin Institute of Technology 2011
- Xie , Y. , Liu , Y. , Wang , Y. Friction Compensation for a Pneumatic Proportional Valve Based on Dither Effect JOURNAL OF VIBRATION AND SHOCK 27 2 107 180 2008
- Taghizadeh , M. , Ghaffari , A. , and Najafi , F. Modeling and Identification of a Solenoid Valve for PWM Control Applications Comptes Rendus Mecanique 337 131 400 2009