This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Upper-Load Extension of a Boosted Direct Injection Poppet Valve Two-Stroke Gasoline Engine
Technical Paper
2016-01-2339
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Engine downsizing can effectively improve the fuel economy of spark ignition (SI) gasoline engines, but extreme downsizing is limited by knocking combustion and low-speed pre-ignition at higher loads. A 2-stroke SI engine can produce higher upper load compared to its naturally aspirated 4-stroke counterpart with the same displacement due to the double firing frequency at the same engine speed. To determine the potential of a downsized two-cylinder 2-stroke poppet valve SI gasoline engine with 0.7 L displacement in place of a naturally aspirated 1.6 L gasoline (NA4SG) engine, one-dimensional models for the 2-stroke gasoline engine with a single turbocharger and a two-stage supercharger-turbocharger boosting system were set up and validated by experimental results. The simulation results show that when a single-stage turbocharger with wastegate is used in the two-cylinder 2-stroke poppet valve gasoline engine, a compressor with high pressure ratio at low mass flow rate should be selected in order to maintain the positive pressure difference between intake and exhaust ports. The maximum brake torque of the turbocharged 2-stroke gasoline engine cannot reach that of the NA4SG engine at 1000 rpm and 1500 rpm. Its maximum brake power at 3000 rpm is lower than that of the NA4SG engine at 6000 rpm. However, in the case of two-stage serial boosting system with a supercharger and a downstream turbocharger, the 2-stroke poppet valve gasoline engine can produce the torque and power of the NA4SG engine.
Authors
Topic
Citation
Fu, X., He, B., and Zhao, H., "The Upper-Load Extension of a Boosted Direct Injection Poppet Valve Two-Stroke Gasoline Engine," SAE Technical Paper 2016-01-2339, 2016, https://doi.org/10.4271/2016-01-2339.Also In
References
- Ito , N. , Ohta , T. , Kono , R. , Arikawa , S. et al. Development of a 4-Cylinder Gasoline Engine with a Variable Flow Turbo-charger SAE Technical Paper 2007-01-0263 2007 10.4271/2007-01-0263
- Attard , W. , Konidaris , S. , Toulson , E. , and Watson , H. The Feasibility of Downsizing a 1.25 Liter Normally Aspirated Engine to a 0.43 Liter Highly Turbocharged Engine SAE Technical Paper 2007-24-0083 2007 10.4271/2007-24-0083
- Turner , J. , Popplewell , A. , Patel , R. , Johnson , T. et al. Ultra Boost for Economy: Extending the Limits of Extreme Engine Downsizing SAE Int. J. Engines 7 1 387 417 2014 10.4271/2014-01-1185
- Wyczalek , F. Two-Stroke Engine Technology in the 1990's SAE Technical Paper 910663 1991 10.4271/910663
- Heywood , J.B. , Sher , E. The Two-Stroke Cycle Engine: Its Development, Operation, and Design New York Taylor and Francis 1999 1-56032-831-2
- Hundleby , G. Development of a Poppet-Valved Two-Stroke Engine - The Flagship Concept SAE Technical Paper 900802 1990 10.4271/900802
- Zhang , Y. , Zhao , H. , Ojapah , M. , Cairns , A. CAI combustion of gasoline and its mixture with ethanol in a 2-stroke poppet valve DI gasoline engine Fuel 109 661 668 2013 10.1016/j.fuel.2013.03.002
- Benajes , J. , Molina , S. , Novella , R.D. , Lima , D. Implementation of the Partially Premixed Combustion concept in a 2-stroke HSDI diesel engine fueled with gasoline Appl Energy 122 94 111 2014 10.1016/j.apenergy.2014.02.013
- Knoll , R. AVL Two-Stroke Diesel Engine SAE Technical Paper 981038 1998 10.4271/981038
- Ma , J. Numerical and Experimental Study of a Boosted Uniflow 2-Stroke Engine Brunel University London 2014
- Zhang , Y. , Zhao , H. Investigation of combustion, performance and emission characteristics of 2-stroke and 4-stroke spark ignition and CAI/HCCI operations in a DI gasoline Appl Energy 130 244 255 2014 10.1016/j.apenergy.2014.05.036
- De Marco , C. , Mattarelli , E. , Paltrinieri , F. , and Rinaldini , C. A New Combustion System for 2-Stroke HSDI Diesel Engines SAE Technical Paper 2007-01-1255 2007 10.4271/2007-01-1255
- Pohorelsky , L. , Brynych , P. , Macek , J. , Vallaude , P. et al. Air System Conception for a Downsized Two-Stroke Diesel Engine SAE Technical Paper 2012-01-0831 2012 10.4271/2012-01-0831
- Brynych , P. , Macek , J. , Tribotte , P. , De Paola , G. et al. System Optimization for a 2-Stroke Diesel Engine with a Turbo Super Configuration Supporting Fuel Economy Improvement of Next Generation Engines SAE Technical Paper 2014-32-0011 2014 10.4271/2014-32-0011
- Osborne , R. , Li , G. , Sapsford , S. , Stokes , J. et al. Evaluation of HCCI for Future Gasoline Powertrains SAE Technical Paper 2003-01-0750 2003 10.4271/2003-01-0750
- Kim , K. , Sakai , H. , Kobayashi , T. , and Nakano , M. Performance of Two/Four Stroke Gasoline HCCI Engine with Electromagnetic Valve Train SAE Technical Paper 2007-01-1868 2007 10.4271/2007-01-1868
- Dahl , D. and Denbratt , I. Valve Profile Adaptation, Stratification, Boosting and 2-Stroke Strategies for Raising Loads of Gasoline HCCI Engines SAE Int. J. Engines 5 3 1033 1045 2012 10.4271/2012-01-1108
- Li , Z.H. , He , B.Q. , and Zhao , H. Influences of intake ports and pent-roof structures on the flow characteristics of a poppet-valved two-stroke gasoline engine Int J Engine Res 11 April 2016 10.1177/1468087416640439
- Tsurushima , T. A new skeletal PRF kinetic model for HCCI combustion Proc Combust Inst 32 2835 2841 2009 10.1016/j.proci.2008.06.018
- Liu , M.B. , He , B.Q. , Yuan , J. , Zhao , H. Combustion Characteristics of a HCCI Engine Fuelled with n-Butanol-Gasoline Blends Trans CSICE 31 324 330 2013
- Chun , K. and Heywood , J. Characterization of Knock in a Spark-Ignition Engine SAE Technical Paper 890156 1989 10.4271/890156
- Borg , J. and Alkidas , A. Investigation of the Effects of Autoignition on the Heat Release Histories of a Knocking SI Engine Using Wiebe Functions SAE Technical Paper 2008-01-1088 2008 10.4271/2008-01-1088
- Federico , M. , Luciano , R. Analysis of Knocking Phenomena in a High Performance Engine Turin, 1st GTI Italian User Conference 2013
- Sato , K. , Ukawa , H. , and Nakano , M. A Two-Stroke Cycle Gasoline Engine with Poppet Valves in the Cylinder Head -Part II SAE Technical Paper 920780 1992 10.4271/920780
- Blair , G. and Kenny , R. Further Developments in Scavenging Analysis for Two-Cycle Engines SAE Technical Paper 800038 1980 10.4271/800038
- http://www.turbobygarrett.com/turbobygarrett/turbochargers
- Gamma Technologies GT-POWER User’s Manual version 7.4