This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Semi-Premixed Diesel Combustion with Twin Peak Shaped Heat Release Using Two-Stage Fuel Injection
Technical Paper
2016-01-0741
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Characteristics of semi-premixed diesel combustion with a twin peak shaped heat release (twin combustion) were investigated under several in-cylinder gas conditions in a 0.55 L single cylinder diesel engine with common-rail fuel injection, super-charged, and with low pressure loop cooled EGR. The first-stage combustion fraction, the second injection timing, the intake oxygen concentration, and the intake gas pressure influence on thermal efficiency related parameters, the engine noise, and the exhaust gas emissions was systematically examined at a middle engine speed and load condition (2000 rpm, 0.7 MPa IMEP). The twin peak shaped heat release was realized with the first-stage premixed combustion with a sufficient premixing duration from the first fuel injection and with the second fuel injection taking place just after the end of the first-stage combustion. Optimizing the first-stage combustion fraction and the second injection timing to the position of the twin peak shape heat release, significant reductions in engine noise when compared with the premixed diesel combustion with a single injection were achieved, in addition to improved indicated thermal efficiency and decreased NOx emissions and without increases in other exhaust gas emissions, including the CO, THC, and smoke emissions. These excellent characteristics, with the exception of the smoke emissions, were confirmed for a wide range of intake oxygen concentrations. However, very large reductions in intake oxygen results in increases in the smoke emissions. Increasing the intake gas pressure effectively reduces the smoke emissions at lower intake oxygen concentrations and improves the indicated thermal efficiency, maintaining the low engine noise.
Recommended Content
Authors
Citation
Ogawa, H., Shibata, G., Sakane, Y., Arisawa, T. et al., "Semi-Premixed Diesel Combustion with Twin Peak Shaped Heat Release Using Two-Stage Fuel Injection," SAE Technical Paper 2016-01-0741, 2016, https://doi.org/10.4271/2016-01-0741.Also In
References
- Akihama , K. , Takatori , Y. , Inagaki , K. , Sasaki , S. et al. Mechanism of the Smokeless Rich Diesel Combustion by Reducing Temperature SAE Technical Paper 2001-01-0655 2001 10.4271/2001-01-0655
- Hasegawa , R. and Yanagihara , H. HCCI Combustion in DI Diesel Engine SAE Technical Paper 2003-01-0745 2003 10.4271/2003-01-0745
- Ickes , A. M. , Bohac , S. V. , and Assanis , N. D. Effect of fuel cetane number on a premixed diesel combustion mode Int. J. Engine Res. 2009 10 4 251 263
- Li , T. , Okabe , Y. , Izumi , H. , Shudo , T. et al. Dependence of Ultra-High EGR Low Temperature Diesel Combustion on Fuel Properties SAE Technical Paper 2006-01-3387 2006 10.4271/2006-01-3387
- Li , T. , Izumi , H. , Shudo , T. , Ogawa , H. et al. Characterization of Low Temperature Diesel Combustion with Various Dilution Gases SAE Technical Paper 2007-01-0126 2007 10.4271/2007-01-0126
- Li , T. , Suzuki , M. , and Ogawa , H. Effects of in-cylinder temperature and fuel air mixing quality on smokeless low temperature diesel combustion Proc. COMODIA 2008 135 142
- Li , T. , Suzuki , M. , and Ogawa , H. Characteristics of Smokeless Low Temperature Diesel Combustion in Various Fuel-Air Mixing and Expansion of Operating Load Range SAE Technical Paper 2009-01-1449 2009 10.4271/2009-01-1449
- Li , T. , Moriwaki , R. , and Ogawa , H. Dependence of premixed low-temperature diesel combustion on fuel ignitability and volatility Int. J. Engine Res. 2012 13 1 14 27
- Ogawa , H. , Li , T. , and Miyamoto , N. Characteristics of low temperature and low oxygen diesel combustion with ultra-high EGR Int. J. Engine Res. 2007 8 4 365 378
- Sakai , A. , Takeyama , H. , Ogawa , H. , and Miyamoto , N. Improvements in PCCI combustion and emissions with lower distillation temperature fuels Int. J. Engine Res. 2005 6 5 433 442
- Takeda , Y. , Keiichi , N. , and Keiichi , N. Emission Characteristics of Premixed Lean Diesel Combustion with Extremely Early Staged Fuel Injection SAE Technical Paper 961163 1996 10.4271/961163
- Xiong , Q. , Inaba , K. , Ogawa , H. , and Shibata , G. Influence of Fuel Properties on Operational Range and Thermal Efficiency of Premixed Diesel Combustion SAE Int. J. Fuels Lubr. 6 3 1005 1013 2013
- Xiong , Q. , Inaba , K. , Obe , T. , Ogawa , H. et al. Improvements in Thermal Efficiency of Premixed Diesel Combustion with Low Distillation Temperature Fuels SAE Technical Paper 2013-01-2624 2013 10.4271/2013-01-2624
- Ogawa , H. , Xiong , Q. , Obe , T. , Sakane , Y. et al. Improvements in Thermal Efficiency of Premixed Diesel Combustion with Optimization of Combustion Related Parameters and Fuel Volatilities International Journal of Engine Research (IMech E) 16 1 2015 81 91
- Akagawa , H. , Miyamoto , T. , Harada , A. , Sasaki , S. et al. Approaches to Solve Problems of the Premixed Lean Diesel Combustion SAE Technical Paper 1999-01-0183 1999 10.4271/1999-01-0183
- Hashizume , T. , Miyamoto , T. , Akagawa , H. , and Tsujimura , K. Emission characteristics of a MULDIC combustion diesel engine: effects of EGR JSAE Review 23 3 428 430 1999
- Horibe , N. , Harada , S. , Ishiyama , T. , and Shioji , M. Improvement of premixed charge compression ignition based combustion by two-stage injection Int. J. Engine Res. 2009 10 2 71 80
- Kitamura , T. and Ito , T. Mixing-Controlled, Low Temperature Diesel Combustion with Pressure Modulated Multiple-Injection for HSDI Diesel Engine SAE Int. J. Engines 3 1 461 478 2010 10.4271/2010-01-0609
- Kuzuyama , H. , Machida , M. , Kawae , T. , Tanaka , T. et al. High Efficiency and Clean Diesel Combustion Concept using Double Premixed Combustion: D-SPIA SAE Technical Paper 2012-01-0906 2012 10.4271/2012-01-0906
- Fuyuto , T. , Taki , M. , Ueda , R. , Hattori , Y. et al. Noise and Emissions Reduction by Second Injection in Diesel PCCI Combustion with Split Injection SAE Int. J. Engines 7 4 1900 1910 2014 10.4271/2014-01-2676
- Ikeda , H. , Iida , N. , Kuzuyama , H. , Umehara , T. et al. An Investigation of Controlling Two-Peak Heat Release Rate for Combustion Noise Reduction in Split-Injection PCCI Engine using Numerical Calculation SAE Technical Paper 2014-32-0132 2014 10.4271/2014-32-0132