This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A BCI-Test Simulation Model for In-Vehicle Equipment
Technical Paper
2016-01-0045
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In this paper, consideration is made to create a simulation model of the BCI test method, which is one of the EMC evaluation methods for in-vehicle electronic devices, and an intrinsic model of a BCI probe is provided. Using this model, it is demonstrated that when the impedance of the BCI probe is sufficiently high, the BCI probe serves as a transformer with a winding ratio of 1:1, and the admittance of a line or a load connected to each wire becomes proportional to the magnitude of current flowing in each wire. This model can also be applied when the leakage inductance inside the BCI probe is taken into consideration. The validity of this model is verified by experiment using a jig which can clamp multiple wires.
In addition, by using this model, it is demonstrated that the S-parameters for dozens of wires clamped in the BCI probe can be generated using the S-parameter measurement results from when one wire is in the BCI probe.
Recommended Content
Authors
Citation
Uno, T., Ichiro, A., and Hara, Y., "A BCI-Test Simulation Model for In-Vehicle Equipment," SAE Technical Paper 2016-01-0045, 2016, https://doi.org/10.4271/2016-01-0045.Also In
References
- Orlandi , Antonio Circuit model for bulk current injection test on shielded coaxial cables Electromagnetic Compatibility, IEEE Transactions on 45.4 2003 602 615
- Orlandi , Antonio , Giulio Antonini , and Romeo Michele Rizzi Equivalent circuit model of a bundle of cables for bulk current injection (BCI) test Electromagnetic Compatibility, IEEE Transactions on 48.4 2006 701 713
- Grassi , Flavia , Filippo Marliani , and Sergio A. Pignari Circuit modeling of injection probes for bulk current injection Electromagnetic Compatibility, IEEE Transactions on 49.3 2007 563 576
- Miropolsky , Sergey , Stephan Frei , and Jörg Frensch Modeling of Bulk Current Injection (BCI) Setups for Virtual Automotive IC tests EMC Europe 2010
- Grassi , Flavia , and Sergio A. Pignari Characterization of the bulk current injection calibration-jig for probe-model extraction Electromagnetic Compatibility (EMC), 2010 IEEE International Symposium on. IEEE 2010
- Durier , André et al. Novel modeling strategy for a BCI set-up applied in an automotive application: An industrial way to use EM simulation tools to help hardware and ASIC designers to improve their designs for immunity tests Electromagnetic Compatibility of Integrated Circuits (EMC Compo), 2011 8th Workshop on. IEEE 2011
- Miropolsky , Sergey , Stephan Frei , and Jörg Frensch Modeling of Bulk Current Injection (BCI) Setups for Virtual Automotive IC tests EMC Europe 2010
- Oguri , and Ichikawa Simulation method for automotive electronic equipment immunity testing Electromagnetic Compatibility (EMC EUROPE), 2012 International Symposium on IEEE 2012
- Gheonjian , A. et al. Modeling of BCI test setup applied to common rail pressure control system Electromagnetic Compatibility (EMC Europe), 2014 International Symposium on IEEE 2014