This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Engine and After-Treatment System Performance within the Cold Start Transient: New Modelling and Experiments
Technical Paper
2015-24-2506
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Nowadays, due to catalyst improvements and electronic mixture control of last generation vehicles equipped with internal combustion engine, the most significant part of the total emissions of carbon monoxide and unburned hydrocarbons takes place during the cold phase, if compared with those exhausted in hot conditions, with a clear consequence on air quality of urban contexts. The purpose of this research, developed by the Department of Industrial Engineering of the University of Naples Federico II with reference to an European background, is a deeper analysis of the engine and after-treatment system behaviour within the cold start transient and the evaluation of cold start additional emissions: a methodology was developed and optimized to evaluate the cold transient duration, the emitted quantities during the cold phase and the relevant time-dependence function.
The whole procedure was applied on the exhaust emissions of one scooter belonging to the Euro-3 legislative category, equipped with catalytic converter, and with a displacement of 280 cm3. Experimental tests were performed on a chassis dynamometer in cold and hot functioning conditions, during both driving cycle regulated by law and real world driving cycles. The study was focused on this specific vehicle because the pertinent information aren't very extensive in scientific literature, with particular reference to the appraisal of real world and cold-start extra emissions of this particular two-wheeler vehicular class (Euro-3 legislative category and displacement between 250 and 750 cm3), which in the last years is taking on an increasing chief role in private mobility.
Citation
Iodice, P. and Senatore, A., "Engine and After-Treatment System Performance within the Cold Start Transient: New Modelling and Experiments," SAE Technical Paper 2015-24-2506, 2015, https://doi.org/10.4271/2015-24-2506.Also In
References
- Roberts , A. , Brooks , R. , and Shipway , P. Internal combustion engine cold-start efficiency: A review of the problem, causes and potential solutions Energy Conversion and Management 82 327 350 2014
- Goettler , H. , Vidger , L. , and Majkrzak , D. The Effect of Exhaust-to-Coolant Heat Transfer on Warm-up Time and Fuel Consumption of Two Automobile Engines SAE Technical Paper 860363 1986 10.4271/860363
- Jarrier , L. , Champoussin , J. , Yu , R. , and Gentile , D. Warm-Up of a D.I. Diesel Engine: Experiment and Modeling SAE Technical Paper 2000-01-0299 2000 10.4271/2000-01-0299
- Andrews , G. , Harris , J. , and Ounzain , A. SI Engine Warm-Up: Water and Lubricating Oil Temperature Influences SAE Technical Paper 892103 1989 10.4271/892103
- André , M. In Actual Use Car Testing: 70,000 Kilometers and 10,000 Trips by 55 French Cars under Real Conditions SAE Technical Paper 910039 1991 10.4271/910039
- Vasic , A.M. and Weilemann , M. Comparison of real-world emissions from two-wheelers and passenger cars Environmental Science & Technology 40 149 154 2006
- European Commission EU energy and transport in figures (2010) Statistical pocketbook 978-92-79-13815-7 2010 10.2768/19814 http://ec.europa.eu/energy/publications/statistics/
- Iodice , P. and Senatore , A. Evaluation of Dispersion Models for Predicting Carbon Monoxide Concentrations from Motor Vehicles in a Metropolitan Area International Review on Modelling and Simulations 6 6 1928 1932 2013
- Prati M.V. , Zamboni , G. , Costagliola , M.A. , Meccariello , G. , Carraro , C. , and Capobianco , M. Influence of driving cycles on Euro 3 scooter emissions and fuel consumption Energy Conversion and Management 52 3327 3336 2011
- Iodice , P. and Senatore , A. Experimental-analytical investigation to estimate an emission inventory from road transport sector IAENG Transactions on Engineering Sciences - Special Issue of the International MultiConference of Engineers and Computer Scientists, IMECS 2013 and World Congress on Engineering, WCE 2013 141 149 2014
- Gkatzoflias , D. , Kouridis , C. , Ntziachristos , L. , and Samaras , Z. COPERT 4 Computer programme to calculate emissions from road transport 2012 http://www.emisia.com/copert/
- Elst , D. , Gense , N.L.J. , Vermeulen , R.J. and Steven , H. Artemis WP500 (powered two-wheelers emissions) -final report EU project ARTEMIS http://www.inrets.fr/ur/lte/publiautresactions/fichesresultats/cadrefichesre suvert.html
- Trapy , J. and Damiral , P. An Investigation of Lubricating System Warm-up for the Improvement of Cold Start Efficiency and Emissions of S.I. Automotive Engines SAE Technical Paper 902089 1990 10.4271/902089
- Will , F. and Boretti , A. A New Method to Warm Up Lubricating Oil to Improve the Fuel Efficiency During Cold Start SAE Int. J. Engines 4 1 175 187 2011 10.4271/2011-01-0318
- Samhaber , C. , Wimmer , A. , and Loibner , E. Modeling of Engine Warm-Up with Integration of Vehicle and Engine Cycle Simulation SAE Technical Paper 2001-01-1697 2001 10.4271/2001-01-1697
- Heywood , J. Internal combustion engine fundamentals McGraw-Hill; 1988 0-07-100499-8
- Zammit , J.P. , Shayler , P.J. , and Pegg , I. Thermal coupling and energy flows between coolant, engine structure and lubricating oil during engine warm-up Presented at VTMS 10 Coventry, U K 2010
- Will , F. Fuel conservation and emission reduction through novel waste heat recovery for internal combustion engines Fuel 247 255 2012
- André , M. The ARTEMIS European driving cycles for measuring car pollutant emissions Science of The Total Environment 334-335 73 84 2004
- Bent , E. , Shayler , P. , and La Rocca , A. The effectiveness of stop-start and thermal management measures to improve fuel economy Presented at VTMS 11 Coventry, UK 2013
- Gardiner , R. , Zhao , C. , Addison , J. , and Shayler , P.J. The effects of thermal state changes on friction during the warm up of a spark ignition engine Presented at VTMS 11 Coventry, UK 2013
- Li , H. , Andrews , G. , Savvidis , D. , Daham , B. et al. Study of Thermal Characteristics and Emissions during Cold Start using an on-board Measuring Method for Modern SI Car Real World Urban Driving SAE Int. J. Engines 1 1 804 819 2009 10.4271/2008-01-1307
- Kunze , K. , Wolff , S. , Lade , I. , and Tonhauser , J. A Systematic Analysis of CO2-Reduction by an Optimized Heat Supply during Vehicle Warm-up SAE Technical Paper 2006-01-1450 2006 10.4271/2006-01-1450
- Iodice , P. , Prati , M. , and Senatore , A. A Calculation Procedure for the Evaluation of Cold Emissive Behavior of High-Performance Motorcycles SAE Technical Paper 2011-24-0200 2011 10.4271/2011-24-0200
- Weilenmann , M. Cold Start and cold ambient Emissions of Euro II cars Proceedings 10th Int. Symp., Transport and Air Pollution Boulder, USA 2001
- Joumard , R. Modelling of cold start emissions for passenger cars INRETS report, LTE 9931 Bron, France 1999
- Iodice , P. and Senatore , A. Cold start emissions of a motorcycle using ethanol-gasoline blended fuels Energy Procedia 45 809 818 2014
- Iodice , P. and Senatore , A. Exhaust emissions of new high-performance motorcycles in hot and cold conditions International Journal of Environmental Science and Technology 2015 10.1007/s13762-014-0741-6
- Shayler , P. , Christian , S. , and Ma , T. A Model for the Investigation of Temperature, Heat Flow and Friction Characteristics During Engine Warm-Up SAE Technical Paper 931153 1993 10.4271/931153